636407
25
Zoom out
Zoom in
Previous page
1/68
Next page
25
www.zanussi.com
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage com
-
partments of the appliance, unless they are of the type recom-
mended by the manufacturer.
Do not use water spray and steam to clean the appliance.
Clean the appliance with a moist soft cloth. Only use neutral de
-
tergents. Do not use abrasive products, abrasive cleaning pads,
solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the manu
-
facturer, its service agent or similarlyqualified persons in order to
avoid a hazard.
Safety Instructions
Installation
WARNING! Only a qualified person
must install this appliance.
Remove all the packaging.
Do not install or use a damaged appliance.
Obey the installation instruction supplied
with the appliance.
Always be careful when you move the ap-
pliance because it is heavy. Always wear
safety gloves.
Make sure the air can circulate around the
appliance.
Wait at least 4 hours before connecting the
appliance to the power supply. This is to
allow the oil to flow back in the compressor.
Do not install the appliance close to radia-
tors or cookers, oven or hobs.
The rear of the appliance must stand
against the wall.
Do not install the appliance where there is
direct sunlight.
Do not install this appliance in areas that
are too humid or too cold, such as the
construction appendices, garages or wine
cellars.
When you move the appliance, lift it by the
front edge to avoid scratching the floor.
Electrical connection
WARNING! Risk of fire and electrical
shock.
The appliance must be earthed.
All electrical connections should be made
by a qualified electrician.
Make sure that the electrical information on
the rating plate agrees with the power sup-
ply. If not, contact an electrician.
Always use a correctly installed shockproof
socket.
Do not use multi-plug adapters and exten-
sion cables.
Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Service or an electrician to change the
electrical components.
The mains cable must stay below the level
of the mains plug.
Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the mains
plug after the installation.
Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZFX31401WA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZFX31401WA in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info