551951

Zanussi ZFC25401 Manual

28
Zoom out
Zoom in
Previous page
1/64
Next page
Problem Possible cause Solution
The cabinet has been recently
switched on and the temperature is
still too high.
Refer to "High Temperature Alarm".
There is too much frost
and ice.
Products are not wrapped properly. Wrap the products better.
The lid is not shut properly or do not
close tightly.
Check if the lid closes well and the
gaskets are undamaged and clean.
The temperature is not set correctly. Set a warmer temperature.
The water drainage plug is not cor-
rectly positioned.
Position the water drainage plug in
the correct way.
The lid doesn't close com-
pletely.
There is excessive frost. Eliminate excess frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
Food packages are blocking the lid. Arrange the packages in the right
way, see the sticker in the appliance.
The lid is difficult to open. The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked. Check the valve.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
It is too warm in the freez-
er.
The temperature is not set correctly. Set a lower temperature.
The lid does not close tightly or it is
not shut properly.
Check if the lid closes well and the
gasket is undamaged and clean.
Before freezing the appliance was
not precooled sufficiently.
Pre-cool the appliance for enough
time.
Large quantities of food to be frozen
were put in at the same time.
Wait some hours and then check the
temperature again. Next time insert
smaller quantities of food to be frozen
at any one time.
Food placed in the appliance was
too warm.
Allow food to cool to room tempera-
ture before storing.
Products to be frozen are placed
too closely to each other.
Place the products in a way so that
cold air could circulate among them.
The lid has been opened often. Try to not open the lid often.
The lid has been opened for a long
time.
Do not leave the lid open longer than
necessary.
It is too cold inside the
freezer.
The temperature is not set correctly. Set a warmer temperature.
The appliance does not
work at all. Neither cooling
nor lighting works.
Plug is not connected to the mains
socket properly.
Connect the mains plug properly.
Power does not reach the appli-
ance.
Try connecting another electrical de-
vice to the power outlet.
The appliance is not switched on. Switch on the appliance.
28
www.zanussi.com
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZFC25401 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZFC25401 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 2,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info