18
Fault code / malfunction Possible cause Solution
Something not working
The dishwasher does not fill with
water.
- continuous flashing of the
light of the running programme
- 1 flash of the "End of
programme" light
The dishwasher will not drain.
- continuous flashing of the
light of the running programme
- 2 flashes of the "End of
programme" light
The water tap is blocked or furred Clean the water tap.
with limescale.
The water tap is turned off. Turn the water tap on.
The filter (where present) in the . Clean the filter in the.
threaded hose fitting at the water threaded hose fitting.
inlet valve is blocked.
The water inlet hose has not been Check the water inlet hose
correctly laid or it is bent or connection.
squashed.
The sink spigot is blocked. Clean out the sink spigot.
The water drain hose has not been Check the water drain hose
correctly laid or it is bent or connection.
squashed.
The programme does not start.
The dishwasher door has not been Close the door
properly closed.
The main plug is not plugged in. Insert the mains plug
The fuse has blown in the household Replace the fuse.
fuse box.
IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
Once these checks have been carried out; press the button of the programme that was running
before the intervention of the alarm. The programme will continue from the point at which it was
interrupted. If the malfunction or fault code reappears contact the Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your
Service Force Centre.
IMPORTANT!
When carrying out the suggested corrective
actions the appliance must be switched off.
- continuous flashing of the
light of the running programme
- 3 flashes of the "End of
programme" light
Anti-flood device has activated. Close the water tap and
contact your local Service
Force Centre.
