Manual Zanussi zc 246 r1 (page 8 of 18) (English, German, Dutch, French)

341240

Zoom out

Zoom in

1/18

Aufstellung

Das GerŠt sollte nicht in der NŠhe von WŠrmequel-len

wie Heizkšrpern oder …fen aufgestellt und vor direkter

Sonneneinstrahlung geschŸtzt werden. Aus GrŸnden der

Sicherheit mu§ eine MindestbelŸftung gesichert sein, wie

aus der Abb. hervorgeht.

Anordnung des GerŠtes unter den OberschrŠnken der

KŸche (siehe Abb.-A). Anordnung des GerŠtes ohne

OberschrŠnke der KŸche (siehe Abb.-B).

Achtung: Die Ventilations - …ffnungen mŸssen immer

saubergehalten werden.

Die Nivellierung erfolgt durch Drehen der am Unter-teil

des GerŠtes angebrachten NivellierfŸ§chen.

100 mm10 mm

10 mm

NP006

Hintere AbstandsstŸcke

Im Beipack sind 2 DistanzstŸcke enthalten, die an der

GerŠte-RŸckseite montiert werden mŸssen.

DistanzstŸcke in die …ffnungen einsetzen (Pfeil A) und

dann um 45¡ bis zum Einhaken drehen (Pfeil A

senkrecht

PR60

45°

D162/1

TŸranschlagwechsel

Bevor Sie nachstehende ArbeitsvorgŠnge durchfŸhren,

Netzstecker unbedingt aus der Steckdose ziehen!

Den Wechsel auf folgende Weise ausfŸhren:

1. Nehmen Sie das untere Scharnier (1), den

Schraubfu§ (2) ab;

2. TŸr vom obere Scharnierstift (G) abschrauben und auf

gegenŸberliegenden Seite wieder anmontieren;

3. Schrauben Sie den linken vorderen Schraubfu§ ab

und schrauben Sie ihn an der gegenŸberliegenden

Seite wieder an;

5. Stšpsel der TŸren entfernen, und auf der

gegenŸberliegenden Seite wieder einsetzen; TŸr

montieren;

6. montieren Sie entsprechend den Angaben in der

Abbildung das untere Scharnier und den Schraubfu§

wieder an der gegenŸberliegenden Seite.

7. Griff(e) abnehmen und auf der gegenŸberliegenden

Seite befestigen. Mit einem Senkstift die Plastikstšpsel

auf der gegenŸberliegenden Seite der Griffe

durchlšchern. Mit den im Beipack enthaltenen

Plastikstšpseln, die freigebliebenen Lšcher abdecken.

Achtung

Vergewissern Sie sich nach AusfŸhrung des An-

schlagwechsels der TŸren, da§ alle Schrauben fest

angezogen sind und ŸberprŸfen Sie auch, ob die

Magnetdichtung am Mšbel perfekt anliegt. Bei einer

niedrigen Raumtemperatur (z.B. im Winter) kann es

vorkommen, dass die Dichtung nicht perfekt am

Schrank haftet. Die Wiederher-stellung der Dichtung

erfolgt automatisch nach gewisser Zeit. Wollen Sie

aber diesen Prozess beschleunige, so genšgt es die

Dichtung mit einem Fšn zu erwŠrmen.

Positioning the door shelves

To permit storage of food packages of various sizes,

the door shelves can be placed at different heights.

To make these adjustments proceed as follows:

Gradually pull the shelf in the direction of the arrows

until it comes free, then reposition as required.

PR260

Movable shelves

The walls of the refrigerator are equipped with a

series of runners so that the shelves can be

positioned as desired.

Cleaning the interior

Before using the appliance for the first time, wash

the interior and all internal accessories with luke-

warm water and some neutral soap so as to remove

the typical smell of a brand-new product, then dry

thoroughly.

Do not use detergents or abrasive

powders, as these will damage the finish.

Operation

Insert the plug into the wall socket.

Open the refrigerator door and turn the thermostat

knob, clockwise, beyond the ÇOÈ (STOP) position.

The appliance will start to operate.

To stop operation, simply turn the thermostat knob to

position ÇOÈ

Temperature regulation

The temperature is automatically regulated and can

be increased to achieve a higher temperature

(warmer) by rotating the thermostat knob toward

lower settings or reduced (colder) rotating the knob

towards higher settings.

However, the exact setting should be chosen

keeping in mind that the temperature inside the

refrigerator depends on:

Fresh food refrigeration

To obtain the best performance:

¥ do not store warm food or evaporating liquids in

the refrigerator;

¥ do cover or wrap the food, particularly if it has a

strong flavour.

¥ Position food so that air can circulate freely round

it.

USE

¥ room temperature;

¥ how often the door is opened;

¥ the quantity of food stored;

¥ location of appliance.

A medium setting is generally the most suitable.

Important

If the ambient temperature is high or the

appliance is fully loaded, and the appliance is

set to the lowest temperatures, it may run

continuously causing frost to form on the rear

wall. In this case the dial must be set to a higher

temperature to allow automatic defrosting and

therefore reduced energy consumption.

D338

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi zc 246 r1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zanussi zc 246 r1 Manual

Product: