Manual Zanussi ZBA14441SC (page 15 of 56) (English, German, Dutch, French, Portuguese)

521338

Zoom out

Zoom in

1/56

• It is advisable to wait at least four hours be-

fore connecting the appliance to allow the

oil to flow back in the compressor.

• Adequate air circulation should be around

the appliance, lacking this leads to over-

heating. To achieve sufficient ventilation fol-

low the instructions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching

or catching warm parts (compressor, con-

denser) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the serv-

icing of the appliance should be carried out

by a qualified electrician or competent per-

son.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in

either its refrigerant circuit or insulation materi-

als. The appliance shall not be discarded to-

gether with the urban refuse and rubbish. The

insulation foam contains flammable gases: the

appliance shall be disposed according to the

applicable regulations to obtain from your local

authorities. Avoid damaging the cooling unit,

especially at the rear near the heat exchanger.

The materials used on this appliance marked

by the symbol

are recyclable.

Operation

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a

medium setting.

Switching off

To turn off the appliance, turn the Temperature

regulator to the "O" position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:

• turn the Temperature regulator toward lower

settings to obtain the minimum coldness.

• turn the Temperature regulator toward high-

er settings to obtain the maximum coldness.

A medium setting is generally the most

suitable.

However, the exact setting should be chosen

keeping in mind that the temperature inside

the appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Important! If the ambient temperature is high

or the appliance is fully loaded, and the

appliance is set to the lowest temperatures, it

may run continuously causing frost to form on

the rear wall. In this case the dial must be set

to a higher temperature to allow automatic

defrosting and therefore reduced energy

consumption.

First use

Cleaning the interior

Before using the appliance for the first time,

wash the interior and all internal accessories

with lukewarm water and some neutral soap

so as to remove the typical smell of a brand-

new product, then dry thoroughly.

www.zanussi.com

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZBA14441SC in the language / languages: English, German, Dutch, French, Portuguese as an attachment in your email.

The manual is 2,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zanussi ZBA14441SC Manual

Product: