The most typical case of clogging up in the defrost water
outlet when you put food wrapped in some paper into the
appliance and this paper contacts back plate of cooling
compartment and freezes to it. If you remove the food right
at this moment the paper will tear and it can cause clogging
up in the outlet by getting into it. So you are asked to be
careful - because of the above - when placing foods
wrapped in paper into the appliance.
In case of increased demand e.g. during heat-
waves, the refrigerator temporarily happens to oper-
ate constantly - during this the automatic defrosting
is ineffective.
Remaining small ice and frost stains on back plate of the
cooling compartment after defrosting period is not abnor-
mal.
Cleaning
Never use metal objects for cleaning your appli-
ance as it may get damaged.
NEVER use detergents, abrasive powders, highly per-
fumed cleaning products or wax polishes to clean the
interior as these will damage the surface and leave a
strong odour.nie Metallgegenstände um das Gerät zu
reinigen, da es beschädigt werden könnte.
Clean the inside with warm water and bicarbonate of soda.
Rinse and dry thoroughly.
To guarantee a safe operation of the fridge, once a year
remove the ventilation grill at the base and clean the air
channels with a vacuum cleaner.
When the appliance is not in use
Disconnect the appliance from the electricity supply.
Empty all foods and clean the appliance, leaving the doors
ajar to prevent unpleasant smells.
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take
the lamp cover off in the direction of arrow and the bulb
can be changed. (Type of the bulb: Mignon 322, 230 V,
15 W, E 14 thread)
After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the refrig-
erator.
38
GB