314889

Zanussi ta 850 Manual

8
Zoom out
Zoom in
Previous page
1/8
Next page
8
8. OPERATING PROBLEMS
Many checks have been carried out during the manufacture of your washing machine. However, if you face a problem with
its operation, please read the following sections before calling the After Sales Service:
If you are unable to identify or to solve the problem, consult
our services department. Before calling, inform yourself
about the model and the date of purchase of your appliance:
the services department will need this information.
Data plate
You will find this information on the data plate (at the back of
the appliance) and on a sticker located on the interneal door
filter.
Symptom Cause
The washing machine will not start or will not fill:
• the washing machine is not correctly connected, the electrical
installation is not working,
• the lid of your washing machine and the drum flaps are not cor-
rectly closed,
• you did not control the program start correctly,
• there is a power failure,
• the water supply is closed off,
• the water tap is closed,
• the water inlet is blocked.
The washing machine fills up but empties again immedia-
tely:
• the drain siphon is attached too low (see installation section).
The washing machine will not spin or will not drain:
• the drain pipe is blocked or kinked,
• the drain filter is blocked,
• the «Drain» program or the «Rinse hold» option is selected,
• the height of the drain siphon is wrong.
There is water on the floor around the washing machine:
• excess detergent has made too much foam that overflowed,
• the detergent is not suitable for machine washing,
• the drain siphon is not hooked on properly,
• the drain filter was not put back into place,
• the water inlet pipe is leaking.
Washing results are not satisfactory:
• the detergent is not suitable for machine washing,
• there is too much washing in the drum,
• the washing program is not appropriate,
• there is not enough detergent.
The machine is vibrating or noisy:
• not all the packing was removed from the machine (see unpac-
king section),
• the washing machine is not leveled and properly packed,
• the washing machine is too close to the wall or furniture,
• the washing is not well distributed in the drum,
• the load is not sufficient.
The washing cycle is much too long: • the water inlet is blocked,
• there was a power supply failure or the water was cut off,
• the motor temperature safety device tripped,
• the water inlet temperature is lower than normal,
The washing machine stops during a washing cycle: • the water or electricity supply is defective,
• a rinse hold was programmed.
The cover does not open during the cycle: • the cover cannot open until 1 to 2 minutes after the
washing machine has stopped.
Softener or Javel water flows
*
through the overflow orifice
when filling:
* depending on model.
• you did not put in the right amount,
• the siphons at the back of the detergent dispenser are
blocked.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ta 850 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ta 850 in the language / languages: English as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info