7
Adjusting the worktop
You can move the worktop forward or backward by 25 mm
in order to align the machine with other kitchen units.
Simply unscrew the two front retaining screws, move the
top to the required position and then retighten the screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it
under a close fitting sink unit or a pre-existing top,
providing the dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing the
two front retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with
the adjustable feet (see Instruction book - Part 1).
When inserting the machine, ensure that the water inlet
and drain hoses are not kinked or squashed.
Hints for test centres
Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser
Test standard: EN 50242
Reference programme: ECONOMY 50°C
Load: 9 standard place settings
Rinse aid selector: position 4
Detergent dosage: 20 g in the dispenser
5 g on the dispenser lid
