528925
69
Zoom out
Zoom in
Previous page
1/72
Next page
Einbau der Backofentür und der Glasscheiben
Nach der Reinigung müssen Backofentür und Glas-
scheiben wieder eingebaut werden. Führen Sie die obi-
gen Schritte in umgekehrter Reihenfolge durch.
Die mittlere Glasscheibe hat einen Dekorrahmen. Ach-
ten Sie beim Einsetzen dieser Scheibe darauf, dass der
bedruckte Bereich zur Innenseite der Tür weist. Versi-
chern Sie sich nach dem Einsetzen, dass sich der
Glasscheibenrahmen in den bedrucken Bereichen nicht
rau anfühlt.
Achten Sie darauf, die oberste Scheibe richtig in ihre
Position einzusetzen. Orientieren Sie sich an der Abbil-
dung.
Was tun, wenn …
Warnung! Siehe Kapitel „Sicherheitshinweise“.
Problem Mögliche Ursache Abhilfe
Das Gerät heizt nicht auf. Das Gerät ist ausgeschaltet. Schalten Sie das Gerät ein.
Die Uhrzeit ist nicht eingestellt. Stellen Sie die Zeit ein.
Die erforderlichen Einstellungen wur-
den nicht vorgenommen.
Prüfen Sie die Einstellungen.
Die Abschaltautomatik ist aktiv. Siehe „Abschaltautomatik".
Die Kindersicherung ist aktiviert. Siehe hierzu „Deaktivieren der Kinder-
sicherung“.
Die Sicherung im Sicherungskasten hat
ausgelöst.
Prüfen Sie die Sicherung.
Falls die Sicherung öfter als einmal
auslöst, wenden Sie sich an einen qua-
lifizierten Elektriker.
Die Backofenlampe leuchtet
nicht.
Die Backofenlampe ist defekt. Wechseln Sie die Backofenlampe aus.
Dampf und Kondenswasser
schlagen sich auf Speisen
und im Backofen nieder.
Die Speisen standen zu lange im Back-
ofen.
Speisen nach Beendigung des Gar-
oder Backvorgangs nicht länger als
15-20 Minuten im Backofen lassen.
Das Display zeigt oder
an, das Gerät heizt nicht
auf und die Luft zirkuliert
nicht.
Der Demo-Modus ist aktiviert. Schalten Sie das Gerät aus. Drücken
Sie
ca. 2 Sekunden. Ein akusti-
sches Signal ertönt. Halten Sie die
Tasten
und gleichzeitig ge-
drückt, bis das akustische Signal ertönt
und die Anzeige erlischt.
Im Display erscheint der
Fehlercode „F..“.
Ein elektronischer Fehler ist aufgetre-
ten.
Notieren Sie den Fehlercode und wen-
den Sie sich an den Kundendienst.
69
69


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker ZKB7630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker ZKB7630 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info