528925

Zanker ZKB7630 Manual

31
Zoom out
Zoom in
Previous page
1/72
Next page
• Clean the front of the appliance with a soft cloth with
warm water and cleaning agent.
• To clean metal surfaces use a usual cleaning agent
• Clean the oven interior after each use. Thus you can
remove dirt more easily and it does not burn on.
• Clean stubborn dirt with a special oven cleaner.
• Clean all oven accessories (with a soft cloth with
warm water and cleaning agent) after each use and
let them dry.
• If you have nonstick accessories, do not clean them
using an aggressive agents, sharp edged objects or
dishwasher. It can destroy nonstick coating!
Cleaning the door gasket
• Regularly do a check of the door gasket. The door
gasket is around the frame of the oven cavity. Do not
use the appliance if the door gasket is damaged.
Contact the Service Centre.
• To clean the door gasket refer to the general infor-
mation about the cleaning.
Pyrolytic cleaning
Warning! The appliance becomes very hot.
There is the risk of burns.
Important! Do not use Pyrolytic cleaning function and
the hob at the same time (if it is installed with the
appliance). It can cause a damage to the appliance.
Before Pyrolytic cleaning:
1. Remove all removable parts from the appliance.
To remove the shelf supports (if present), refer to
"Removing the shelf support rails".
2. Remove the worst of the dirt manually.
3. Close the oven door correctly.
Using the Pyrolytic cleaning
1.
Press
again and again until the display shows
.
–
The display shows “Pyro” and
.
– An acoustic signal sounds to remind you to re-
move all removable parts from the oven.
– The temperature display shows „P1“ or „P2“
– The clock display shows "2:00" or "2:30"
–
Duration
flashes for approximately 5 sec-
onds.
2.
While Duration
flashes, press or to set
the duration for the Pyrolytic cleaning:
– 2:00 for a low degree of dirt,
– 2:30 for a high degree of dirt.
3.
Press
to start the Pyrolytic cleaning.
The bars on the symbol
come on one by one to
show that the temperature in the appliance increa-
ses.
When the appliance is at the preset temperature,
the door locks and the display shows
.
When the Pyrolytic cleaning is completed, the display
shows the time of day. The oven door is locked. When
the appliance cools down, an acoustic signal sounds
and the door unlocks.
To stop the pyrolytic cleaning at any time, press
.
End time for Pyrolytic cleaning
You can set the end time for Pyrolytic cleaning
with the clock function End
.
1. Do again step 1,2 and 3 from above procedure.
2.
Press
.
The display shows an arrow and the symbol
.
The display shows the time for the end of Pyrolytic
cleaning.
3.
Press
or to adjust the time for the end of
the Pyrolytic cleaning.
Removable shelf runners and catalytic panels
To clean the oven cavity remove the shelf runners and
catalytic panels.
Warning! Be careful when you remove the shelf
runners. The catalytic panels are not attached to
the oven cavity and can fall out when you remove the
shelf runners.
Warning! Before maintenance, make sure that
the appliance is cool. There is risk of burns
because of residual heat.
31
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker ZKB7630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker ZKB7630 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info