528942

Zanker WTF968A.8 Manual

22
Zoom out
Zoom in
Previous page
1/32
Next page
• Turn off the water tap.
• Unscrew the hose
from the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
• Unscrew the hose from the machine. Keep a rag
nearby because some water may flow.
• Clean the filter in the valve with a stiff brush or
with the piece of cloth.
35°
45°
• Screw the hose back to the machine and make
sure the connection is tight.
• Turn on the water tap.
Frost precautions
If the machine is installed in a place where the temper-
ature could drop below 0°C, remove the remaining wa-
ter from the inlet hose and the drain pump.
1. disconnect the mains plug from the mains socket.
2. close the water tap
3. unscrew the water inlet hose from the tap;
4. put the two ends of the inlet hose in a container
and let the water flow out of the hose.
5. empty the drain pump as described in the ‘Emer-
gency emptying out’ section.
6. when the drain pump is empty, install the water in-
let hose again.
Warning!
Make sure that the temperature is more than 0 °C be-
fore you use the appliance again.
The manufacturer is not responsible for damages
caused by low temperatures.
Emergency emptying out
If the appliance cannot drain the water, proceed as fol-
lows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has cooled down;
4. open the pump door;
5. place a container on the floor below the recess of
the drain pump;
6. press the two levers and pull forward the drainage
duct to let the water flow out;
7. when the container is full of water, put the drain-
age duct back again and empty the container;
repeat this operation until water stops flowing out;
8. if necessary clean the pump (refer to the section
‘Cleaning the pump’ );
9. close the drain pump door.
When you drain the water with the emergency drain
procedure, you must activate again the drain system:
1. Put 2 litres of water in the main wash compart-
ment of the detergent dispenser.
2. Start the programme to drain the water.
What to do if ...
Certain problems are due to lack of simple mainte-
nance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local
Service Centre, please carry out the checks listed be-
low.
During machine operation it is possible that the red pi-
lot light of button 7 blinks, one of the following alarm co-
des appears on the display and some acoustic signals
sound every 20 seconds to indicate that the machine is
not working:
22
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker WTF968A.8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker WTF968A.8 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zanker WTF968A.8

Zanker WTF968A.8 User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info