528942
3
Zoom out
Zoom in
Previous page
1/32
Next page
Obey the maximum load volume of 8 kg (refer to the “Programme chart”
chapter).
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
The operating water pressure (minimum and maximum) must be between 0,5
bar (0,05 MPa) and 8 bar (0,8 MPa)
The ventilation openings in the base (if applicable) must not be obstructed by
a carpet.
The appliance is to be connected to the water mains using the new supplied
hose-sets. Old hose sets must not be reused.
Safety instructions
Installation
Remove all the packaging and the transit bolts.
Keep the transit bolts. When you move the appliance
again you must block the drum.
Do not install or use a damaged appliance.
Do not install or use the appliance where the temper-
ature is less than 0 °C or where it is exposed to the
weather.
Obey the installation instruction supplied with the ap-
pliance.
Make sure that the floor where you install the appli-
ance is flat, stable, heat resistant and clean.
Do not install the appliance where the appliance
door can not be fully opened.
Always be careful when you move the appliance be-
cause it is heavy. Always wear safety gloves.
Make sure that there is air circulation between the
appliance and the floor.
Adjust the feet to have the necessary space between
the appliance and the carpet.
Electrical connection
Warning! Risk of fire and electrical shock.
The appliance must be earthed.
Make sure that the electrical information on the rat-
ing plate agrees with the power supply. If not, con-
tact an electrician.
Always use a correctly installed shockproof socket.
Do not use multi-plug adapters and extension ca-
bles.
Make sure not to cause damage to the mains plug
and to the mains cable. Contact the Service or an
electrician to change a damaged mains cable.
Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
Do not touch the mains cable or the mains plug with
wet hands.
This appliance complies with the E.E.C. Directives.
Water connection
Make sure not to cause damage to the water hoses.
The appliance is to be connected to the water mains
using the new supplied hose-sets. Old hose sets
must not be reused.
Before you connect the appliance to new pipes or
pipes not used for a long time, let the water flow until
it is clean.
The first time you use the appliance, make sure that
there is no leakage.
Use
Warning! Risk of injury, electrical shock, fire,
burns or damage to the appliance.
Use this appliance in a household only.
3
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker WTF968A.8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker WTF968A.8 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zanker WTF968A.8

Zanker WTF968A.8 User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info