743393
6
Zoom out
Zoom in
Previous page
1/18
Next page
PG 6
Mount the CT32 to Wall
1. Hold the CT32 against the wall, with the wires coming over the top;
above terminal block. The CT32 will cover the hole in the wall.
2. Position CT32 for best
appearance.
3. Attach the CT32 to
the wall with the screws
provided.
4. If you are mounting the
CT32 to sheet rock or if you
are using the old mounting
holes, use the plastic
anchors provided.
5. Mark rst and drill a
3/16-in.(4.8mm) hole for
the insert at each screw
location, then mount the
unit.
• “Fan out” wires as illustrated with CT32 below the wall opening. As
in the example: fan out the wires so that the C wire is above the C
terminal, the W above the W. This allows the CT32 to t snug to the wall.
• Position the Wires behind the CT32 and up over the terminal area.
• Do not bunch wires behind the CT32. Feed any slack back into the
wall opening.
Connect Your Wires
• Connect labeled wires only to a terminal with the same letter label.
• Insert the wire in the terminal well and tighten the screw securely.
NOTE: If you wish you can mount the CT32 to the wall rst, and then
connect the wires.
• The CT32 can be externally powered with a power source rated from
12V to 24V, AC or DC, at 100ma or greater. If used, connect to the C
and RH terminals (no polarity).
from HEAT/COOL system
C
B
O
W
W
2
Y
Y2
R
H
R
C
G
A
Y
G
W
C
RH
G
C
Y
RH
W
2.6"
from HVAC
System
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Z-Wave CT32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Z-Wave CT32 in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info