647898
4
Zoom out
Zoom in
Previous page
1/16
Next page
Skip
The MVT-7100 has a feature called skip, which allows a paused scan or search to resume after a fixed
time. Normally, during a scan or search, if an active transmission is detected, the scanning or searching
operation will be paused until the transmission ceases. Once the transmission goes away, the scanning or
searching operation resumes. If you have the index feature enabled, scanning or searching will pause on
an active transmission for at most 5 seconds before resuming.
Step size
A value in Hertz (Hz) or kiloHertz (kHz) that indicates the amount by which a frequency will be changed due
to user or radio control while searching for active transmissions or using a VFO.
Available step sizes are :
Hz : 50/100
kHz : 1/5/6.25/9/10/12.5/20/25/50/100/125
NOTE: Only the MVT-7200 has the 125 kHz step size
S-meter
A feature used to graphically represent the strength of the signal being received. It is usually calibrated to a
dB (logarithmic) scale. A bar graph is used where more bars indicate a stronger signal.
VFO
A temporary location to store a frequency so that a memory channel does not have to be programmed.
Associated with this frequency are various settings such as receive mode, step size, attenuator, and delay.
Available Modes
Memory
The radio is in Memory mode when a memory channel number is visible in the upper left corner and
followed by the CH indicator. Pressing the MR key toggles between Memory and VFO modes.
Priority
Priority mode is enabled when the PRI indicator is visible. This is a mode independent of the VFO, Memory,
Scanning or Searching modes.
Scanning
In this mode, the scanning operation checks the specified banks for active transmissions on the
programmed frequencies within those banks. There are two scanning modes with three scanning sub-
modes for a total of six different types of scan that can be performed.
The two modes are :
Continuous: scanning of all non-empty banks
Bank: scanning of up to four banks
The three sub-modes are :
Normal: a normal scan
Mode: scans only those channels with the specified receive mode
Program: scans only those channels which have been program tagged
This gives us the following six scan mode types:
Continuous Normal
Continuous Mode
Continuous Program
Bank Normal
Bank Mode
Bank Program
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yupiteru MVT-7100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yupiteru MVT-7100 in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yupiteru MVT-7100

Yupiteru MVT-7100 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info