654141
15
Zoom out
Zoom in
Previous page
1/32
Next page
Troubleshooting
1.Unable or wireless trigger the flash
F
FSet the power switch of transmitter to TX state then test the flash, it could not
test flash when setting to TRX state.
FMake sure the flash have been prepared and set to manual “M” mode.
FThe poor contact between transmitter, camera and flash will cause the triggering
problem, ensure the contacts are clean and have been installed to the correct
position.
2.Unable to awake the flash
FWhen using the non specialized transmitter, it need to half press the button of
transmitter to awake the flash when the transmitter set in TX state. If the flash could
not be awaken, it need to manual awake the flash or turn off the power saving mode.
3.The shutter could not be released
FWhen part of the cameras could not find the focus, it could not proceed to shoot
even if receiving the shooting signal. The focus mode of camera should be adjusted to
M”.
to test the flash
Make sure the battery is full and the transceivers are in the same channel.
12
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yongnuo RF-603II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yongnuo RF-603II in the language / languages: English as an attachment in your email.

The manual is 6,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info