540485

Yokogawa DY Vortex Flowmeter Manual

10
Zoom out
Zoom in
Previous page
1/174
Next page
<2. HANDLING PRECAUTIONS>
2-1
IM 01F06A00-01EN
2. HANDLING PRECAUTIONS
The Model DY Vortex Flowmeter and Model DYA
Vortex Flow Converter are thoroughly tested at the
factory before shipment. When these instruments
are delivered, perform a visual check to ascertain
that no damage occurred during shipment.
This section describes important cautions in
handling these instruments. Read carefully before
using them.
If you have any problems or questions, contact
your nearest YOKOGAWA service center or sales
representative.
2.1 Checking Model and
Specifi cations
The model and important specifi cations are
indicated on the name plate attached to the case.
Verify that they are the same as those specifi ed in
the original order, refer to Chapter 13 “GENERAL
SPECIFICATIONS .” In any correspondence,
always give model (MODEL) and serial number
(NO.) from the name plate.
F0201.ai
TAG NO.
4 ~ 20mA DC / PULSE
MPa at 38°C
10.5 ~ 42V DC
3UA
3UA
*1)
*2)
Figure 2.1(a) Example of Name Plate for Integral Type
F0202.ai
TAG NO.
4 ~ 20mA DC / PULSE
3YA
TAG NO.
3WA
10.5 ~ 42V DC
MPa at 38°C
*1)
*1)
*2)
*2)
Figure 2.1(b) Example of Name Plate for Remote Type
*1): K factor at + 15°C
*2): The product - producing country.
2.2 Transportation and Storage
Precautions
If the instrument is to be stored for a long period of
time after delivery, observe the following points.
(1) The instrument should be stored in its original
packing condition in the storage location.
(2) Select a storage location that fulfi ls the following
conditions:
• A place where it will not be exposed to rain or
water
• A place subject to minimal vibrations or shocks
• Temperature and humidity levels should be as
follows:
Temperature:-40 to +80°C
Humidity:5 to 100% RH (no condensation)
The preferred ambient temperature and
humidity levels are +25°C and approximately
65% RH.
(3) If the digitalYEWFLO vortex fl owmeter is
transferred to the installation site and stored
without being installed, its performance may
be impaired due to the infi ltration of rainwater
and so forth. Be sure to install and wire the
digitalYEWFLO vortex fl owmeter as soon as
possible after transferring it to the installation
location.
(4) The vortex fl owmeter is a heavy instrument. Be
careful that no damage is caused to personnel
through accidentally dropping it, or by exerting
excessive force on the vortex fl owmeter. When
moving the vortex fl owmeter, always use a
trolley and have at least two people carry it.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yokogawa DY Vortex Flowmeter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yokogawa DY Vortex Flowmeter in the language / languages: English as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info