638625
17
Zoom out
Zoom in
Previous page
1/33
Next page
VARINO GRANDE 350 - 600
We reserve the right to make changes to dimensions and construction 15 Edition 10.07.2015
© Copyright YGNIS AG CH-Ruswil
6.7. Hydraulic connection
6.7.1. General notice
For the hydraulic connection of the heating system and water heaters in particular with regards to technical
safety devices such as safety valves, expansion tanks, etc. refer to generally accepted engineering rules as
well as locally applicable standards, specifications and regulations.
If boilers are installed in garret-based heating plants or at the highest point of the heating system, then boilers
will have to be provided with additional safety devices (such as protections against water shortage). Observe the
minimum operating pressure as specified in chapter 4.4. Act in compliance with local safety regulations in force
at all times.
Boiler’s maximum operating pressure and the maximum operating temperature are given in chapter 4.1.
No minimum level of the amount of circulating water is required.
6.7.2. Water quality
Observe the required water quality according chapter 4.2. Anti-freeze should not be used.
Before connecting the boiler to an old installation, it is necessary to flush the whole heating system.
It is recommended to provide for a sludge separator.
Damage can occur from corrosion when oxygen continuously enters the heating water through open
installations, expansion tanks that are too small, floor heaters with pipe material that is not oxygen-tight, etc.
If this cannot be prevented, additional measures are necessary in the form of correctly used oxygen binding
agents or chemicals. If it is not possible to realize an installation without oxygen entrance, a system separation
must be set up using heat exchangers.
6.7.3. Boiler return flow
The condensing unit is fitted with a high temperature return flow in addition to the normal low temperature return
flow. Heating elements are connected to these with the maximum temperature level.
In order to ensure a high degree of efficiency of the boiler in each operating condition, care should be taken to
ensure that the low temperature return flow is supplied in each case.
It is not necessary to maintain the return flow temperature at a given level.
6.7.4. Draining the condensate
The condensates that result during condensation contain combustion products that are more or less acidic. Any
necessary approval for draining the condensate into the sewer system must be obtained from local authorities.
A condensate neutralisation set is available as an option, if desired
If the condensate is drained directly into the sewer system, then this must take place via an open funnel/hopper.
Important:
The recuperator is delivered with a siphon arranged in the casing. It must be ensured that no additional
siphon is installed since this would prevent the condensate from draining away. For the same reason, the
line to the funnel/hopper must have a slight gradient and should not show any slack!
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ygnis VARINO GRANDE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ygnis VARINO GRANDE in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ygnis VARINO GRANDE

Ygnis VARINO GRANDE Installation Guide - English, German, Dutch - 48 pages

Ygnis VARINO GRANDE Usermanual and installation guide - Dutch - 34 pages

Ygnis VARINO GRANDE Installation Guide - French, Italian, Spanish - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info