813461
16
Zoom out
Zoom in
Previous page
1/28
Next page
16
Servicing Instructions
3. Servicing Requirements
DURING SERVICING OF THIS APPLIANCE IT MAY
BE NECESSARY TO CUT CABLE TIES IN ORDER
TO ACCESS AND REMOVE SOME OF THE PARTS.
THESE MUST BE REPLACED WHEN
REASSEMBLING THE APPLIANCE.
WARNING: The Effect Spindles are sharp, please
use caution when servicing this appliance.
THIS APPLIANCE MUST ONLY BE SERVICED BY A
SUITABLY QUALIFIED PERSON.
BEFORE UNDERTAKING ANY WORK ON THE APPLIANCE:
SWITCH OFF THE APPLIANCE AND ISOLATE THE POWER
SUPPLY ENSURING THERE IS NO POWER TO THE
APPLIANCE.
3.1 Wait for at least 10 minutes until the appliance has cooled
down.
3.2 Remote Handset Battery Replacement
Replace with 2 AAA batteries. Make sure the batteries are
installed correctly in the remote control.
3.3 Maintenance of Motors
The motor used on the flame effect is pre-lubricated for
extended bearing life and requires no further lubrication.
However, periodic cleaning/vacuuming of the heater unit is
recommended.
3.4 Resetting the Thermal Cutout Switch
The appliance is fitted with an Electronic Safety Control
(E.S.). This is a safety device which switches off the fire if,
the appliance overheats for any reason e.g. when covered.
If the heater stops operating whilst the flame effect
continues normally, this indicates that the E.S. Control is in
operation.
The E.S. Control can only be re-set after the appliance has
cooled down.
To re-set the E.S:
Switch off the appliance (Manual On/Off switch) and leave
for approximately 2 hours.
Remove any obstruction to the fan heater outlet or other
internal parts.
Switch on appliance and the E.S. Control will re-set. Ensure
that the appliance is functioning correctly. If the E.S. Control
operates again, the appliance should be checked by a
competent Electrician.
4. Cast Front & Exterior Glass
IMPORTANT: THE OUTER PANELLING IS MADE
FROM CAST IRON. USE CAUTION WHEN
INSTALLING, REMOVING AND STORING AS THE
COMPONENTS ARE HEAVY AND SHOULD BE
HANDLED CAREFULLY.
EXMOOR & DARTMOOR SINGLE DOOR
4.1 Turn and pull right hand rose to open door, see Diagram 3.
3Dartmoor Shown
4.2 Pull the door open.
DARTMOOR DOUBLE DOOR
4.3 To open the door turn the knob on the right door to release
the catch, see Diagram 4.
4
4.4 Pull the doors open.
ALL MODELS
4.5 Remove the top 3 screws and bracket securing the front
glass to the appliance, see Diagram 5.
Take care to support the glass when removing the screws.
5
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yeoman Exmoor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yeoman Exmoor in the language / languages: English as an attachment in your email.

The manual is 4.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info