56 57
Your Robomower has three blades, xed to the blades disk.
Unless damaged by hard obstacles, these blades can last for up to ve month of everyday
use.
Weekly inspection of the blades and the xing screws is required. Note that the blades are
double-edged. Once the rst side is blunt, loosen the xing screw. Turn the blade upside-
down and x it again with the xing screw. After tightening the xing screw, verify that the
blade can rotate freely around the screw.
A set of spare blades is included with the Robomower. More are available from customer
support. The blade's spare part number is 846210.
Only use original spare parts. For best performance and avoiding impalance, always turn or
replace all three blades at the same time.
Replacing the battery
While the actual battery life will depend on usage and environmental factors, the typical
service life is several years. Spare batteries are available from customer support. To
replace the battery, please follow the instructions below.
1) Ensure the main power switch (11) is turned OFF. Clean the underside as instructed.
2) Set the Robomower to the lowest cutting height.
3) Turn the mower upside-down. Remove the 5 screws xing the battery compartment's lid.
Note one screw is partially covered by the blade protector and is only accessible through
a service hole.
4) Pull out the battery and disconnect it from the Robomower
5) Carefully clean the lid and the edge of the battery compartment. Debris may allow
excessive water entering the battery compartment, causing major damage to the device.
6) Connect and insert the replacement battery, close the compartment and x the lid with 5
screws. Do not turn on the Robomower before placing it back on its wheels - beware of
sharp blades!
Short-time storage
• Store the machine in a dry place well out of reach of children.
• Do not wrap nylon sacks around the machine, as this could result in the formation of
moisture.
CLEANING/MAINTENANCECLEANING/MAINTENANCE
