514483
586
Zoom out
Zoom in
Previous page
1/596
Next page
7-21
SETTING
TUN
EC72H010
Suspension setting
9
Front fork
NOTE:
9
If any of the following symptoms is experienced with the standard position as the base, make reset-
ting by reference to the adjustment procedure given in the same chart.
9
Before any change, set the rear shock absorber sunken length to the standard figure 90~100 mm
(3.5~3.9 in).
Section
Symptom
Jump
Large
Medium
Small Check Adjust
gap gap gap
Compression damping Turn adjuster counterclockwise (about 2 clicks)
Stiff over entire
to decrease damping.
range
111 Oil amount Decrease oil amount by about 5~10 cm
3
(0.2~0.4
Imp oz, 0.2~0.3 US oz).
Spring Replace with soft spring.
Outer tube Check for any bends, dents, and other notice-
Unsmooth
Inner tube able scars, etc. If any, replace affected parts.
movement over 1111
Slide metal Replace with a new one for extended use.
entire range
Piston metal Replace with a new one for extended use.
Under bracket tightening
Retighten to specified torque.
torque
Poor initial
Rebound damping Turn adjuster counterclockwise (about 2 clicks)
movement
1 to decrease damping.
Oil seal Apply grease in oil seal wall.
Compression damping Turn adjuster clockwise (about 2 clicks) to in-
Soft over entire crease damping.
range, bottoming 11 Oil amount Increase oil amount by about 5~10 cm
3
(0.2~0.4
out Imp oz, 0.2~0.3 US oz).
Spring Replace with stiff spring.
Stiff toward stroke
1
Oil amount
Decrease oil amount by about 5 cm
3
(0.2 Imp oz,
end 0.2 US oz).
Soft toward stroke
1
Oil amount
Increase oil amount by about 5 cm
3
(0.2 Imp oz,
end, bottoming out 0.2 US oz).
Stiff initial
1111
Compression damping
Turn adjuster counterclockwise (about 2 clicks)
movement to decrease damping.
Compression damping Turn adjuster clockwise (about 2 clicks) to in-
crease damping.
Low front, tending
Rebound damping Turn adjuster counterclockwise (about 2 clicks)
to lower front 11
to decrease damping.
posture
Balance with rear end Set sunken length for 95~100 mm (3.7~3.9 in)
when one passenger is astride seat (lower rear
posture).
Oil amount Increase oil amount by about 5 cm
3
(0.2 Imp oz,
0.2 US oz).
Compression damping Turn adjuster counterclockwise (about 2 clicks)
to decrease damping.
Obtrusive front,
Balance with rear end Set sunken length for 90~95 mm (3.5~3.7 in)
tending to upper 11
when one passenger is astride seat (upper rear
front posture
posture).
Spring Replace with soft spring.
Oil amount Decrease oil amount by about 5~10 cm
3
(0.2~0.4
Imp oz, 0.2~0.3 US oz).
1P8-9-32-7 4/28/06 3:48 PM Page 46
586


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha YZ250LC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha YZ250LC in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 15,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info