516954
23
Zoom out
Zoom in
Previous page
1/59
Next page
21 En
Initial settings
PREPARATION
CONNECTION/
INITIAL SETTINGS PLAYBACK SETTINGS
TROUBLESHOOTING
APPENDIX
Error messages for AUTO SETUP
If an error message is displayed on your TV, check the error
message list to solve the problem and then follow the procedure
below.
[ERROR E-1]: Press ENTER key to run the AUTO SETUP
procedure again. Or press Z key to continue the
measurement.
[ERROR E-7], [ERROR E-9]: Press key to turn this unit
to standby mode, then run AUTO SETUP procedure again after
turning this unit on.
Other errors: Press RETURN key to cancel the operation
and then run the AUTO SETUP procedure again.
If the problem is difficult to be solved, configure the settings
manually in “SETUP MENU” (p. 36).
ERROR E-1: Please test in quieter environment.
Cause Remedy
There is too much unwanted
noise in your listening room.
Make sure that your listening
room is as quiet as possible. You
may want to choose certain hours
during the day when there is not
much noise coming from outside.
ERROR E-2: No MIC detected. Please check MIC
connection and re-try.
Cause Remedy
The IntelliBeam microphone is
not connected to this unit or
disconnected during the AUTO
SETUP procedure.
Connect the IntelliBeam
microphone to this unit firmly.
ERROR E-3: Unexpected control is detected. Please
re-try.
Cause Remedy
Some other operations were
performed on this unit while the
AUTO SETUP procedure was in
progress.
Do not perform any other
operations while the AUTO
SETUP procedure is in progress.
ERROR E-4: Please check MIC position. MIC should
be set in front of the Sound Projector and re-try.
Cause Remedy
The IntelliBeam microphone is
not placed in front of this unit.
Make sure that the IntelliBeam
microphone is installed in front
of this unit.
ERROR E-5: Please check MIC position. MIC should
be set above 1.8m/6.0ft and re-try.
Cause Remedy
The IntelliBeam microphone is
not placed in the right distance
from this unit.
Make sure that the IntelliBeam
microphone is installed more
than 1.8 m (6.0 ft) from the front
of this unit and within 1 m (3.3
ft) from the center height of this
unit.
ERROR E-6: Volume level is lower than expected.
Please check MIC position/connection and re-try.
Cause Remedy
The IntelliBeam microphone
cannot collect the sound
produced by this unit because the
sound output level is too low.
Make sure that the IntelliBeam
microphone is firmly connected
to this unit and placed in a proper
location. If the problem persists,
contact the nearest
authorized Yamaha service
center for assistance.
ERROR E-7: Unexpected error happened. Please
turn off and re-try.
Cause Remedy
An internal system error
occurred.
Press key to turn this unit
to standby mode, then run AUTO
SETUP procedure again after
turning this unit on.
ERROR E-9: Turn off and check the connection with
subwoofer.
Cause Remedy
Subwoofer is not connected. Press key to turn this unit
to standby mode, connect the
subwoofer (p. 13). After that,
run AUTO SETUP procedure
again.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha YSP-2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha YSP-2200 in the language / languages: English as an attachment in your email.

The manual is 4,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha YSP-2200

Yamaha YSP-2200 User Manual - English - 2 pages

Yamaha YSP-2200 Quick start guide - German - 2 pages

Yamaha YSP-2200 User Manual - German - 59 pages

Yamaha YSP-2200 Quick start guide - Dutch - 2 pages

Yamaha YSP-2200 User Manual - Dutch - 59 pages

Yamaha YSP-2200 Quick start guide - French - 2 pages

Yamaha YSP-2200 User Manual - French - 59 pages

Yamaha YSP-2200 Quick start guide - Swedish - 2 pages

Yamaha YSP-2200 User Manual - Swedish - 59 pages

Yamaha YSP-2200 Quick start guide - Spanish - 2 pages

Yamaha YSP-2200 User Manual - Spanish - 59 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info