599652
29
Zoom out
Zoom in
Previous page
1/44
Next page
YDP-113 Keyboard Stand Assembly
ENGLISH
29
Keyboard Stand Assembly
CAUTION
Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
Assembly should be carried out by at least two persons.
Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
Be sure to tighten up all screws upon completing assembly of each unit.
•To disassemble, reverse the assembly sequence given below.
Remove the following parts from the package.
1. Attach the center panel (B) to the side
panels (C).
The center panel (B) is installed between the side pan-
els (C). The brackets on each end of the center panel
should face the rear of the stand assembly. Place the
square holes in the center-panel brackets over the lugs
extending from the side panels, then slide down the
center panel. Each side of the center panel is attached
using two 6 × 16 mm flat-head screws.
2. Install the main unit (A).
CAUTION
Fingers can become pinched between the main
unit and the rear or side panels, be extra careful so
as not to drop the main unit.
Do not hold the keyboard in any position other
than the position shown in the illustration.
Place the main unit (A) on the side panels (C) with the
screws on its bottom panel (toward the rear of the main
unit) just behind the grooves in the brackets located at
the top of the side panels. Then slide the main unit for-
ward until it stops.
Align the holes in the bottom panel of the main unit
with the holes in the brackets on the side panels. (C
en-
ter the main unit to produce equal clearance on the left
and right sides, as shown in the illustration.) Then use
the four 6 × 16 mm flat-head screws to attach the main
unit. Two screws can be attached from the front side
and two screws from the rear.
Have a Phillips-head (+) screwdriver ready
Assembly Parts
6 × 16 mm flat-head screws ×8
Cord holders ×2
Damper pedal
AC power cord
C
A
C
B
6 x 16 mm flat-head screw
C
B
NOTE
If the holes of the front side brackets are not aligned with the
screw hole, position the sides of the side panels so that they
are parallel with the side of the unit.
10 cm
10 cm
C
A
A
6 x 16 mm flat-head screw
C
A
Be sure to place your
hands at least 10 cm
from either end of the
main unit when posi-
tioning it.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha YDP-113 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha YDP-113 in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha YDP-113

Yamaha YDP-113 User Manual - German - 44 pages

Yamaha YDP-113 User Manual - German - 2 pages

Yamaha YDP-113 User Manual - French - 2 pages

Yamaha YDP-113 User Manual - French - 44 pages

Yamaha YDP-113 User Manual - Italian - 42 pages

Yamaha YDP-113 User Manual - Spanish - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info