3 Remove the four screws from the cover.
4 Insert the module into the socket by fol-
lowing the procedure below.
4-1
Insert the module vertically in the socket and
position the screws (of the module) to the
female screws respectively.
4-2 Press the top of the connector as shown, then
push the connector firmly into the socket.
4-3 Tighten each screw of the module to each
female screw of the Tyros5 with your hand as
shown.
5 Re-install the cover you removed in step
3, in reverse order.
Removing Flash Memory Expansion
Module
1 Loosen both the screws with your hand
as shown below.
2 Pull the module vertically out of the
socket.
3 Attach the cover to the bottom panel.
Keep the removed screws in a safe place. They will be used when reattaching the
cover to the instrument after installation.
• If you cannot loosen the screws with your hand, use a Phillips
screwdriver. In this case, be careful NOT to scratch the module or
the Tyros5.
• Be careful NOT to drop the screws inside the instrument when loos-
ening them.
