16
Calling a preset RDS station by the program type (PTY SEEK)
By designating a program type, the unit automatically searches RDS stations of that program type from among all preset stations.
* There are 15 program types to classify RDS stations. For details, refer to page 13.
1 Turn the unit into the PTY mode.
* If “NO PTY” flashes, proceed to the next step while
flashing. If “NO PTY” disappears before you proceed to the
next step, press the FREQ/PS/PTY button once or twice.
2
3 Select the desired program type.
* By turning the TUNING control, the display will change
program types in sequence.
4 When the desired program type appears, press the
ENTER button.
5
The unit begins searching among all preset stations, and
calls a station of the program type if such a station is found.
* When the TUNING control is turned clockwise, the search
is performed from “A1” toward higher numbers of the
preset stations (A1, A2 ... A8, B1, B2, ...). If, however,
“A3” is currently being called for example, the search
begins from the next station “A4”.
When the TUNING control is turned counterclockwise, the
search is performed in reverse order.
If the called station is not the desired one, turn the TUNING
control again to search for another station of the same
program type.
To cancel this function
Press the AF, FREQ/PS/PTY, SHIFT, ENTER, FM/AM or
MEMORY button.
Note
If no station is found by this function, after searching through
all preset stations, “NO PTY” flashes for about 3 seconds on
the display, and then it returns to the mode which had been
obtained before the searching was performed.
3, 5
1
4
2
