19288
13
Zoom out
Zoom in
Previous page
1/20
Next page
11
English
PREPARATION
ADJUSTING SPEAKER OUTPUT LEVELS
3 Adjust the level of each speaker by pressing
VOLUME +/ so that it matches the level of
the front speakers.
While adjusting, the test tone is heard from the
selected speakers. After or + is released, the test
tone begins travelling to another speaker again.
4 When adjustment is complete, press TEST to
stop the test tone.
While adjusting, the level of the selected speaker is shown
by the lighting of the VOLUME indicators on the front
panel. The default level is also shown by the dim lighting
of the corresponding indicator.
y
You can enjoy listening to the input source at the desired
volume simply by turning VOLUME on the front panel or
pressing VOLUME +/ on the remote control.
Notes
If you press INPUT on the remote control when the test tone is
outputted, the output levels of all channels are reset to the
default levels.
The levels of the left and right front speakers cannot be set over
the point on the VOLUME indicator shown in the figure below.
This section explains how to adjust speaker output levels
using the test tone generator. When this adjustment is
complete, the output level heard at the listening position
should be the same from each speaker. This is important
for best performance of the various decoders (Dolby
Digital, Dolby Pro Logic II and DTS).
Note
Since this system cannot enter the test mode while headphones
are connected to the amplifier unit, be sure to unplug the
headphones from the
SILENT jack when using the test
tone.
Using the test tone
Use the test tone to balance the output levels of the
speakers.
Notes
The adjustment of each speaker output level should be made at
your listening position using the remote control.
The test tone may not be heard if the volume level of this
system is too low. Confirm that the volume is set to a proper
listening level.
1 Press to turn on the power.
2 Press TEST to output the test tone.
The test tone is heard (in order) from the left front,
center, right front, right rear and left rear speaker.
The tone is produced for about 2.5 seconds from
each speaker.
All of the INPUT indicators flash while the test tone is
being outputted.
INPUT
MODE
REAR
MUTE
TEST
S.WOOFER
VOLUME
VOLUME +/
TEST
Right frontLeft front
Right rear
Left rear
Center
VOLUME
7
6
5
4
3
2
1
+6
+4
+2
0
2
4
6
TRIM
PL MOVIE
PL
MUSIC
SILENT
DIGITAL 1
DIGITAL 2
ANALOG
DTS
INPUT
MODE
VOLUME
DIGITAL
7
6
5
4
3
2
1
+6
+4
+2
0
2
4
6
TRIM
PL MOVIE
PL
MUSIC
STANDBY/ON
TSS-10Eng(UB)a 02.7.31, 2:35 PM11
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha TSS10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha TSS10 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info