19288
8
Zoom out
Zoom in
Previous page
1/20
Next page
6
SETTING UP THE SYSTEM
Placing a center speaker on top of the
monitor
When placing the center speaker on top of the monitor,
remove the stand from the speaker, and attach the
provided fastener at the bottom of the speaker and on top
of the monitor to prevent the speaker from falling.
* Do not place the speaker on top of the monitor with an
inclination of more than 10 degrees.
Note
Though this speaker is a magnetically shielded type, there may
be some influence on the monitor picture depending on the
type of monitor or the placement of the speaker. In such a case,
place the speaker further apart from the monitor until there is
no influence on the monitor picture.
Mounting the amplifier unit on the
supplied stand
For improved stability, it is recommended to mount the
amplifier unit on the supplied stand with the supplied
screws as shown below.
* Attach the supplied non-skid pads at the four corners on the
bottom of the stand for improved stability.
10؇
10؇
Fastener
Adjusting the front angle of the front/
center/rear speakers
The front angle of the speakers can be adjusted as shown
below.
1 Loosen the screw on the bottom of the speaker stand.
* Attach the supplied non-skid pads at the four corners on
the bottom of the stand for improved stability.
2 Adjust the speaker angle on the stand as you prefer,
and then tighten the screw.
Mounting the front/center/rear speakers
on a wall
The speakers can also be hung on the wall.
Remove the stand from the speaker. Fasten screws into a
firm wall or wall support as shown in the figure, and hang
the slits on the rear of the speaker on the protruding
screws.
* Make sure that the screws are securely caught by the slits.
Warning
Each speaker weighs 0.4 kg (0.9 lbs.). Do not mount them on
thin plywood or a wall with soft surface material. If mounted,
the screws may come out of the flimsy surface and the speakers
may fall. This could damage the speakers and cause personal
injury.
Do not install the speakers on a wall with nails, adhesives, or
any other unstable hardware. Long-term use and vibrations
may cause them to fall.
To avoid accidents resulting from tripping over loose speaker
cables, fix them to the wall.
Non-skid
pads
Tapping screw (Diam. 4 mm)
(Available in hardware stores)
50 mm
Min.
20 mm
5 mm
Wall/ wall
support
Non-skid
pads
TSS-10Eng(UB)a 02.8.1, 10:08 PM6
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha TSS10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha TSS10 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info