554620

Yamaha SRT-1000 Manual

21
Zoom out
Zoom in
Previous page
1/194
Next page
19
En
Remote control
No surround
effect.
Stereo playback is selected. Select the surround mode key to
change for surround playback (p.10).
The volume is too low. Turn up the volume (p.8).
The volume of the surround left
and right channels is low.
Turn up the volume of the surround left
and right channels (p.11).
The TV or playback device is set
to output 2-channel audio (such
as PCM) only.
Change the digital audio output setting
on the TV or playback device.
The correct SRT position mode is
not selected.
Select a SRT POSITION key on the
remote control which is best suited for
your listening environment.
Sound beams are not reflected
effectively off walls because of the
shape of the room, etc.
Use of the sound reflection board (sold
separately) is recommended (p.21).
Noise is heard.
The unit is too close to another
digital or high-frequency device.
Move those devices away from the
unit.
Problem Cause Remedy
The unit cannot
be controlled
using the remote
control.
The unit is out of the operating
range.
Use the remote control within the
operating range (p.2).
The batteries are weak. Replace with new batteries (p.2).
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
Adjust the lighting angle, or reposition
the unit.
The unit does
not learn TV
remote control
operations.
The TV remote control key was
not held down long enough.
Hold down the key for more than 1
second twice or three times (p.14).
The TV remote control does not
use infrared signals. (Some
remote controls may not work
even if it uses infrared signals.)
The TV remote control learning
function cannot be used in this case.
Use the supplied remote control to
operate the unit.
The position where you operated
the TV remote control is not
appropriate.
Operate the TV remote control at the
appropriate position (p.14).
The batteries of the TV remote
control are weak.
Replace with new batteries.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
Adjust the lighting angle, or reposition
the unit.
The transmission of the remote
control signal was disturbed by
the TV screen light.
Turn off the TV and perform the
learning operation again (p.14).
Sound is coming
from the TV
when the unit
volume is turned
up with the TV
remote control.
(when TV remote
control learning
function is used)
Audio output is enabled on the
TV.
Change the TV setting to disable the
TV speaker output. If a setting to
disable the speaker output is not
available on your TV, try the following
methods.
- Connect headphones to the
headphone jack on the TV.
- Set the TV volume to minimum.
The power of the
unit and of the
TV switch in the
opposite
direction. (For
example, the TV
is turned off if
the unit is turned
on.)
(when TV remote
control learning
function is used)
The power of the TV was on when
you performed the learning
operation.
Press the power key on the TV and
(power) on the front panel of the
unit to turn them on and then press the
power key on the TV remote control to
turn them off.
… 21 …


Need help? Post your question in this forum.

Forumrules
1

Forum

yamaha-srt-1000

Reset search

  • Where is the headphone jack to connect wireless headphones? Any help thanks. Submitted on 2-4-2017 at 10:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha SRT-1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha SRT-1000 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 29,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info