586917
53
Zoom out
Zoom in
Previous page
1/156
Next page
53
Basics
Section
8Turn the [PAGE] knob and open the LYR
Mode (Layer Mode) page. Set “on” for “Arp”
(Arpeggio switch). Select “1” for “RcvCh”
(MIDI Receive Channel).
9Turn the [PAGE] knob and open the ARP
Type (Arpeggio Type) page. Set “on” for
“Switch.”
In steps 6to 9, you now complete settings
for the lower range for Arpeggiator
performance. It will play in a Voice assigned
to Part 1 based on MIDI Receive channel 1.
Refer to page 67 for detailed settings of
Arpeggiator.
You can copy (reuse) the arpeggio settings that
belong to the Voice assigned to Part 1 (page 123).
)As in the same manner as in steps 6to 8,
make settings for the upper range. So you can
use the Knob A and select “Part02”, select a
Voice for solo performance in the MIX Vce page,
set “2” for “RcvCh” in the LYR Mode page.
Now you are ready for solo performance within
the upper range. You can play in a Voice
assigned to Part 2 based on MIDI Receive
channel 2.
If you set “on” to “Layer” in the LYR Mode
page, the RcvCh setting will be ignored.
For unwanted Parts in Split play, set their MIDI
Receive channels (RcvCh) to other than those
used for the lower and upper Parts. In the
example above, the “RcvCh” values for Part 3 to
16 must be set to any other than 1 and 2.
In Performance Edit Mode, you can make
detailed settings for every Part. In case that a
Part does not sound, make sure the volume
setting for that Part. For more information,
refer to page 115.
!Before exiting Performance Edit Mode, store
above settings in a Performance. For storing a
Performance, refer to page 124.
In Performance Play Mode, recall the Performance
you have just stored. Simply pressing the
[MASTER KEYBOARD] key activates or
deactivates the Split configuration you made
above.
4 Zones
The illustration below shows an example of a 4-
Zone configuration. A zone refers to a specific key
range on the keyboard. You can logically divide a
keyboard into up to four key ranges with separate
ARPíType) Type Tempo Switch Hold
Common UpOct1:Sq 120 on off
LYRíMode) Mode Arp Layer RcvCh
Part01 poly on off 1
MIDI channels and other associated settings so that
you can control multiple Parts at the same time. A
Split setting can divides the entire keyboard into
two absolute sections (key ranges). In a 4-zone
setting, however, each section can overlap to one
another. You can even set a section to cover or
include other sections.
In the following example, Zone 1 is set up for
performance by the Arpeggiator, Zone 2 for bass
sound, Zone 3 manual solo performance, and Zone 4
for playing an external MIDI tone generator. Also in
this settings, Zones 3 and 4 overlap in the same range,
and entire performance in four all zones is output
from the MIDI OUT connector so that you can
record that performance on an external MIDI
sequencer. You can make this configuration in the
following steps.
Before you set up a 4-Zone configuration in the
following procedure, edit and prepare necessary
Voices (for Arpeggiator and manual play) in
their associated Edit Modes.
1Press the [PERFORM] key, followed by the
[EDIT] key (each LED will light) to enter
Performance Edit Mode. Then, press the
[MASTER KEYBOARD] key to activate
Master Keyboard Mode (the LED will light).
2Select “Common” using the Knob [A], then
open the GEN M. Kbd (General Master
Keyboard) screen using the [PAGE] knob.
Turning the [PAGE] knob while holding down
the [SHIFT] key enables you to scroll though
parameters in the Menu screens (page 106).
GENíM.Kbd) Mode Lower Upper Point
Common split ch01 ch02 C 3
ZONE2 ZONE3ZONE1
ZONE4
Ch1
Part1
Performance
with Arpeggiator
Ch2
Part2
Bass Sound
Performance
Ch3
Part3
Manual solo
performance
Ch4
An external
MIDI tone generator
Ch4
Performance with
an external MIDI
tone generator
Recording entire performance
in Zones 1 to 4
An external MIDI sequencer
MIDI OUT
MIDI IN
MIDI THRU
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha S30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha S30 in the language / languages: English as an attachment in your email.

The manual is 5,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha S30

Yamaha S30 User Manual - English - 30 pages

Yamaha S30 Installation Guide - English - 24 pages

Yamaha S30 User Manual - German - 30 pages

Yamaha S30 Installation Guide - German - 24 pages

Yamaha S30 User Manual - German - 156 pages

Yamaha S30 User Manual - Dutch - 154 pages

Yamaha S30 User Manual - French - 156 pages

Yamaha S30 User Manual - French - 30 pages

Yamaha S30 Installation Guide - French - 24 pages

Yamaha S30 User Manual - Italian - 155 pages

Yamaha S30 User Manual - Italian - 12 pages

Yamaha S30 User Manual - Portuguese - 288 pages

Yamaha S30 User Manual - Spanish - 152 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info