516915
50
Zoom out
Zoom in
Previous page
1/166
Next page
En 50
CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
Message list
When a warning message is displayed before measurement
Error messages
Warning messages
NOTE
If the following messages appear, resolve the problems that have occurred and carry out the
measurement process again.
Connect MIC! The YPAO microphone is not connected. Connect the YPAO microphone to the YPAO MIC
jack on the front panel.
Unplug HP! The headphones are connected. Remove the headphones.
Memory Guard! The settings of this unit are protected. Set “Memory Guard” in the Setup menu to “Off”
(p. 114).
E-1:
No Front SP
The unit was not able to find the front
channel.
Check that the left and right front speakers are
connected correctly.
E-2:
No Sur. SP
The unit was only able to find one of side
of the surround channels.
Check that the left and right surround speakers are
connected correctly.
E-3:
No F.PRNS SP
The unit was only able to find one of side
of the front presence channels.
Check that the left and right front presence speakers
are connected correctly.
E-4:
SBRSBL
Only one surround back speaker is
connected and only the right side surround
back channel sound is detected.
When only one surround back speaker is connected,
connect to the left side (SINGLE) terminal.
E-5:
Noisy
The noise is too loud, preventing accurate
measurements from being taken.
Measure again in quiet surroundings. Turn off any
devices in the room that may be emitting noise, or
place them further away from the YPAO
microphone.
When this message is displayed, selecting
“PROCEED” will allow you to continue measuring.
However, we recommend resolving the problem and
measuring again, as continuing measurement without
doing so will not give accurate results.
E-6:
Check Sur.
Even though surround left and right
speakers are not connected, only the
surround back speakers are connected.
When using surround back speakers, connection of
the surround left/right speakers is necessary.
E-7:
No MIC
The YPAO microphone has been removed. While measuring, take care not to touch the YPAO
microphone.
E-8:
No Signal
The YPAO microphone could not
distinguish a test tone.
Check that the YPAO microphone has been
installed correctly.
Check that each speaker has been connected and
installed correctly.
The YPAO microphone or the YPAO MIC jack may
be broken. Inquire at the retailer where you
purchased this unit, or the nearest Yamaha service
center.
E-9:
User Cancel
You have carried out an operation that has
cancelled the measuring process.
Carry out the measuring process again. Do not
operate this unit by, for example, adjusting the
volume.
E-10:
Internal Error
An internal error has occurred. Carry out the measuring process again. Contact a
Yamaha service center if “E-10” is displayed again.
E-11:
No R.PRNS SP
The unit was only able to find one of side
of the rear presence channels.
Check that the left and right rear presence speakers
are connected correctly.
W-1:
Out of Phase
The speakers displayed are connected with
the opposite polarity. Depending on the
type of speakers you are using and the
environment in which you have them
installed, this message may occur even if
the speakers are connected correctly.
Depending on the type of speakers, “W-1” may
display even if the speakers are connected correctly.
Check that the speaker polarity + (positive), and -
(negative) are correct. If these are connected
correctly, you can use the speakers normally even
this message appears.
W-2:
Over 24m/80ft
The speakers displayed are separated from
the listening position by more than 24 m,
and cannot be adjusted correctly.
Install the speakers with 24 m of the listening
position.
W-3:
Level Error
Volume level varies greatly for individual
channels, and cannot be adjusted correctly.
Check that all speakers are installed in the same
surroundings.
Check that the speaker polarity + (positive), and -
(negative) are correct.
We recommend the same speakers or speakers with
as similar specifications as possible.
Adjust the volume of the subwoofer.
If “W-2” or “W-3” appears, you can apply measurement results, but they will not give optimal
results. We recommend that you resolve the problem and carry out the measurement process again.
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha RX-V3067 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha RX-V3067 in the language / languages: English as an attachment in your email.

The manual is 22,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha RX-V3067

Yamaha RX-V3067 Quick start guide - English - 8 pages

Yamaha RX-V3067 User Manual - German - 166 pages

Yamaha RX-V3067 Quick start guide - German - 8 pages

Yamaha RX-V3067 Quick start guide - Dutch - 8 pages

Yamaha RX-V3067 User Manual - Dutch - 166 pages

Yamaha RX-V3067 User Manual - French - 166 pages

Yamaha RX-V3067 Quick start guide - French - 8 pages

Yamaha RX-V3067 User Manual - Italian - 166 pages

Yamaha RX-V3067 Quick start guide - Italian - 8 pages

Yamaha RX-V3067 Quick start guide - Swedish - 8 pages

Yamaha RX-V3067 User Manual - Swedish - 166 pages

Yamaha RX-V3067 User Manual - Spanish - 166 pages

Yamaha RX-V3067 Quick start guide - Spanish - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info