532568

Yamaha R-N500 Manual

13
Zoom out
Zoom in
Previous page
1/420
Next page
11 En
Connections
PREPARATION
English
■ Setting the speaker impedance
Under its default settings, the unit is configured for 8-ohm
speakers. When connecting 4 to 6-ohm speakers, set the
speaker impedance to “4 MIN”.
1 Before connecting speakers, connect the
power cable to an AC wall outlet.
2 While holding down RETURN on the front
panel, press A (power).
3 Check that “SP IMP.” is displayed on the
front display.
4 Press SELECT/ENTER to select “4 MIN”.
5
Press
A
(power) to set the unit to turn off and
remove the power cable from the AC wall outlet.
You are now ready to connect the speakers.
■ Connecting speaker cables
Speaker cables have two wires. One is for connecting the
negative (-) terminal of the unit and the speaker, and the
other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to the
negative and the other wire to the positive terminal.
a
Remove approximately 10 mm (3/8”) of insulation from the ends of
the speaker cable and twist the bare wires of the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side (upper
right or bottom left) of the terminal.
d Tighten the terminal.
■ Bi-wire connection
Bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. With these connections, the mid and
high frequency drivers are connected to one set of terminals
and the low frequency driver to another set of terminals.
Connect the other speaker to the other set of terminals in
the same way.
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
y
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B on the front panel or on the remote control so that
both SP A and B light up on the front display.
Connecting the speakers
A (power)
SELECT/ENTER
RETURN
SPIMP.8MIN
10 mm
(3/8")
aa
b
b
d
d
c
c
Note
This unit
Speaker
SPEAKERS A/B
SPEAKERS
A/B
SOURCE
ID
RECEIVER
CODE SET
SLEEP
DIMMER
SPEAKERS
A B
COAX1
COAX2
OPT1
OPT2
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha R-N500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha R-N500 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 12,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info