464228
47
Zoom out
Zoom in
Previous page
1/76
Next page
PSR-E333/YPT-330 Owner’s Manual
47
Troubleshooting
Problem Possible Cause and Solution
When the instrument is turned on or off, a popping
sound is temporarily produced.
This is normal and indicates that the instrument is receiving electrical power.
When using a mobile phone, noise is produced. Using a mobile phone in close proximity to the instrument may produce inter-
ference. To prevent this, turn off the mobile phone or use it further away from
the instrument.
There is no sound even when the keyboard is played or
when a song or style is being played back.
Check that nothing is connected to the PHONES/OUTPUT jack on the rear
panel. When a set of headphones is plugged into this jack, no sound is output.
Check the Local Control on/off setting. (See page 42 Function 028.)
Not all of the voices seem to sound, or the sound seems
to be cut off.
The instrument is polyphonic up to a maximum of 32 notes — including Dual
voice, Split Voice, auto accompaniment, song, and Metronome.
Notes exceeding this limit will not sound.
Playing keys in the right hand area of the keyboard does
not produce any sound.
When using the Dictionary function (page 22), the keys in the right hand area
are used only for entering the chord root and type.
The Style or Song does not play back when the [START/
STOP] button is pressed.
Is External Clock set to ON? Make sure External Clock is set to OFF; refer to
“Function Settings” on page 42 (Function 029).
The ACMP ON indicator does not appear when the
[ACMP ON/OFF] button is pressed.
Always press the [STYLE] button first when you are going to use any Style-
related function.
The Style does not sound properly.
Make sure that the Style Volume (page 41 Function 001) is set to an appropri-
ate level.
Is the Split Point set to an appropriate key for the chords you are playing? Set
the Split Point to an appropriate key (page 41 Function 005).
Is the “ACMP ON” indicator showing in the display? If it is not showing, press
the [ACMP ON/OFF] button so that it does show.
The auto accompaniment will sometimes not change when related chords
are played in sequence (e.g., some minor chords followed by the minor sev-
enth).
Two-note fingerings will produce a chord based on the previously played
chord.
Playing two same root keys in the adjacent octaves produces accompani-
ment based only on the root.
The footswitch (for sustain) seems to produce the oppo-
site effect. For example, pressing the footswitch cuts off
the sound and releasing it sustains the sounds.
The polarity of the footswitch is reversed. Make sure that the footswitch plug is
properly connected to the SUSTAIN jack before turning on the power.
The sound of the voice changes from note to note. This is normal. The AWM tone generation method uses multiple recordings
(samples) of an instrument across the range of the keyboard; thus, the actual
sound of the voice may be slightly different from note to note.
The harmony doesn’t sound. The method of sounding the harmony effect (01–26) differs depending on the
selected type. For Types 01–05, turn the Auto Accompaniment on and play it
by pressing a chord in the auto accompaniment section of the keyboard, then
play some keys in the right-hand side to get the harmony effect. For Types
06–26, turning auto accompaniment on or off has no effect. However, it is nec-
essary to play two notes simultaneously for Types 06–12.
The volume is too soft.
The sound quality is poor.
The rhythm stops unexpectedly or will not play.
The recorded data of the song, etc. does not play cor-
rectly.
The LCD display suddenly goes dark, and all panel
settings are reset.
The batteries are low or dead. Replace all six batteries with completely new
ones, or use the optional AC adaptor.
Power suddenly and unexpectedly turns off. This is normal and the Auto Power Off function may have been activated
(page 9). If you need to disable the Auto Power Off function, select “Off” in the
Function settings (page 43 Function 040).
Appendix
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha PSR-E333 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha PSR-E333 in the language / languages: English as an attachment in your email.

The manual is 5,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha PSR-E333

Yamaha PSR-E333 User Manual - German - 80 pages

Yamaha PSR-E333 User Manual - Dutch - 76 pages

Yamaha PSR-E333 User Manual - French - 80 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info