635592
12
Zoom out
Zoom in
Previous page
1/160
Next page
12
10
Setting Up
This section contains information about setting up your PSR-540 and preparing to play.
Be sure to go through this section carefully before turning the power on.
CAUTION
Never interrupt the power
supply (e.g. remove the
batteries or unplug the AC
adaptor) during any PSR-
540 record operation!
Doing so can result in a
loss of data.
Power supply connections
Although the PSR-540 will run either from an optional AC adaptor or batteries,
Yamaha recommends use of the more environmentally safe AC adaptor. Follow the
instructions below according to the power source you intend to use.
Using An Optional AC Power Adaptor
1
Make sure that the STANDBY/ON switch of the
PSR-540 is set to STANDBY.
WARNING
Use ONLY a Yamaha PA-6
AC Power Adaptor (or
other adaptor specifically
recommended by Yamaha)
to power your instrument
from the AC mains. The
use of other adaptors may
result in irreparable
damage to both the
adaptor and the PSR-540.
Unplug the AC Power
Adaptor when not using
the PSR-540, or during
electrical storms.
Using Batteries
For battery operation the PSR-540 requires six 1.5V SUM-1, “D” size, R-20 or equiva-
lent batteries. When the batteries need to be replaced, “Battery Low” may appear on
top of the display, the volume may be reduced, the sound may be distorted, and other
problems may occur. When this happens, turn the power off and replace the batteries.
Replace the batteries as follows:
CAUTION
When the batteries run
down, replace them with a
complete set of six new
batteries. NEVER mix old
and new batteries.
Do not use different kinds
of batteries (e.g. alkaline
and manganese) at the
same time.
If the instrument is not to
be in use for a long time,
remove the batteries from
it, in order to prevent
possible fluid leakage from
the battery.
Plugging or unplugging
the AC power adaptor
while the batteries are
installed will reset the
PSR-540 to the defaults.
3
Plug the AC adaptor into an AC outlet.
When turning the power OFF, simply reverse the
procedure.
1
Open the battery compartment cover located on the instrument’s bottom panel.
2
Insert the six new batteries, being careful to follow the polarity markings on the
inside of the compartment.
3
Replace the compartment cover, making sure that it locks firmly in place.
2
Connect the AC adaptor (PA-6 or other adaptor
specifically recommended by Yamaha) to the
power supply jack.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha PSR-540PC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha PSR-540PC in the language / languages: English as an attachment in your email.

The manual is 3,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info