516897
153
Zoom out
Zoom in
Previous page
1/164
Next page
Troubleshooting
153
PF-1000
Auto accompaniment chords are recognized
regardless of the split point or where chords
are played on the keyboard.
This is normal if the ngering mode is set to Full Keyboard or AI Full Keyboard.
If either of these is selected, chords are recognized over the entire range of the
keyboard, irrespective of the split point setting. If desired, select a different
ngering mode (page 62).
Certain notes sound at the wrong pitch. The Scale parameter has probably been set to something other than Equal,
changing the tuning system of the keyboard. Make sure Equal is selected as
the Scale in the Scale Tune page (page 124).
Some channels do not properly play back
when playing back song data.
Make sure that playback of the relevant channel(s) is turned on (page 76).
The Harmony function does not operate. Harmony cannot be used with the Full Keyboard or AI Full Keyboard ngering
modes. Select an appropriate ngering mode (page 62).
The microphone input signal cannot be
recorded.
This is normal; recording the audio input of the microphone is not possible.
MIDI data is not transmitted or received via
the MIDI terminals, even when MIDI cables
are connected properly.
Make sure the HOST SELECT switch is set to MIDI (page 144). The MIDI
terminals cannot be used for the other switch settings.
When a voice is changed, the previously
selected effect is changed.
Each voice has its own suitable preset values which are automatically recalled
when the corresponding Voice Set parameters are turned on (page 132).
There is a slight difference in sound quality
between notes played on the keyboard.
Some voices have a looping sound.
Some noise or vibrato is noticeable at higher
pitches, depending upon the voice.
This is normal and is a result of the PF-1000s sampling system.
Some voices will jump an octave in pitch
when played in the upper or lower registers.
This is normal. Some voices have a pitch limit which, when reached, causes this
type of pitch shift.
Even though a Registration Memory setting
containing a User voice is selected, the Open/
Save display shows a Preset voice.
This is normal; even with the Preset voice shown, the actual sounding voice is
the selected User voice. When a User voice is registered to the User drive or
oppy disk, the actual registered is: 1) the source Preset voice, and 2) the
parameter settings as set in the Sound Creator. When you recall a Registration
Memory setting containing a User voice, the PF-1000 selects the Preset voice
(on which the User voice is based), then applies the relevant parameter settings
to it so that your original User voice is sounded.
Disk save operations take a long time. This is normal. Keep in mind that it takes approximately 1 minute to save 1
megabyte of data to a oppy disk.
The voice produces excessive noise. Certain voices may produce noise, depending on the Harmonic Content and/or
Brightness settings in the FILTER page of the Mixing Console display
(page 118).
The sound is distorted or noisy. The volume may be turned up too high. Make sure all relevant volume settings
are appropriate.
This may be caused by the effects. Try canceling all unnecessary effects,
especially distortion-type effects (page 119).
Some lter resonance settings in the Custom Voice Creator display (page 88)
can result in distorted sound. Adjust these settings if necessary.
A strange “flanging or doubling sound
occurs. Also, the sound is slightly different
each time the keys are played.
Both the Main and Layer parts are set to ON, and both parts are set to play the
same voice. Set the Layer part to OFF (page 56) or change the voice for each
part (page 54).
Problem Possible Cause and Solution
153


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha PF1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha PF1000 in the language / languages: English as an attachment in your email.

The manual is 5,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha PF1000

Yamaha PF1000 User Manual - English, German - 36 pages

Yamaha PF1000 User Manual - German - 164 pages

Yamaha PF1000 User Manual - Dutch - 162 pages

Yamaha PF1000 User Manual - French - 36 pages

Yamaha PF1000 User Manual - French - 164 pages

Yamaha PF1000 User Manual - Italian - 164 pages

Yamaha PF1000 User Manual - Spanish - 36 pages

Yamaha PF1000 User Manual - Spanish - 163 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info