555566
20
Zoom out
Zoom in
Previous page
1/164
Next page
17 En
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instructions given below do not help, disconnect the power cord and contact your authorized Yamaha dealer or
service center.
When an excessive level of signal is input to this unit for 5 to 15 minutes, the POWER indicator starts flashing to alarm
you of the danger of damaging the power amplifier and speaker of this unit. If the signal input lasts for 5 minutes more,
this unit turns into the standby mode automatically.
When an enormous amount of signal is input, the power of this unit is turned off immediately. To turn on this unit again,
press STANDBY/ON switch on the front panel.
TROUBLESHOOTING
Problem Cause Remedy
Power is not supplied even though
the STANDBY/ON switch is
pressed.
The power plug is not securely connected. Connect it securely.
The POWER switch is set to the OFF
position.
Set the POWER switch to the ON
position.
No sound. The volume is set to the minimum (0). Raise the volume.
Speaker cables are not connected securely. Connect them securely.
The signals from the amplifier are too low. Increase the volume of the amplifier or the
component connected to the amplifier.
The signal from the subwoofer output
terminal of the amplifier is not output.
Check the speaker mode setting on the
amplifier.
Sound level is too low. Speaker cables are not connected correctly. Connect them correctly, that is L (left) to
L, R (right) to R, “+” to “+” and
“–” to “–”.
Setting of the phase is not proper. Set the phase to the other position.
A source sound with few bass frequencies is
being played.
Play a source sound with bass
frequencies.
Set the H-CUT to a higher position.
It is influenced by standing waves. Relocate the subwoofer or change its
positioning angle.
The remote control does not
work.
Wrong distance or angle. Use the remote control within a maximum
range of 6 m and no more then 30 degrees
off-axis from the front panel.
Direct sunlight or lighting from an inverter
type of fluorescent lamp etc. is striking the
remote control sensor of this unit.
Reposition this unit.
The batteries are weak. Replace all batteries.
There are obstacles between the remote
control signal receiver on the unit and the
remote control.
Remove the obstacles.
This unit is not turned on with the
remote control of the amplifier.
(when setting “Operating the
power of this unit using the
remote control of your
amplifier”)
Wrong distance or angle. Place this unit within the operating range
of the remote control of the amplifier.
The household breaker goes off. This unit consumes much electricity when a
high level signal is input to this unit.
Turn down the volume on the amplifier
etc. connected to this unit or cut off the
power of other unused equipment.
An object has fallen into the port. Do not try to remove the object. Attempting
to remove the object may cause a
malfunction.
Contact an authorized Yamaha dealer or
service center.
Notes
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha NS-SW901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha NS-SW901 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 5,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info