586887
288
Zoom out
Zoom in
Previous page
1/320
Next page
MOTIF XS Owner’s Manual
288
Appendix
Troubleshooting
No sound? Wrong sound? When a problem like this occurs, please check the following points before assuming that the
product is faulty. You may solve your problem by executing the Factory Set (page 22) after backing up your data to an
external storage device. If the problem persists, consult your Yamaha dealer.
No Sound.
Are all eight sliders set to appropriate levels (other than zero or minimum)?
Is the MOTIF XS properly connected to related external equipment (e.g., amplifier, speaker, headphone) via audio cables?
Since the MOTIF XS has no built-in speakers, you will need an external audio system or a set of stereo headphones to properly
monitor it.
Check the Local Control parameter and the mLAN Monitor Setup parameter in the Utility mode.
When the MOTIF XS is used as stand alone and the Local Control parameter is set to off or the mLAN Monitor Setup parameter is
set to “with PC,” no sound is produced even if you play the keyboard.
Is the power of this synthesizer and any external equipment connected to this synthesizer turned on?
Have you made all the appropriate level settings—including the Master Volume on this synthesizer and the volume settings on
any connected external equipment?
Is the Foot Controller pressed down (when it is connected to the FOOT CONTROLLER jack)?
Are the MIDI volume or MIDI expression settings too low when using the external controller?
Is this synthesizer properly connected to related external equipment (e.g., amplifier or speaker) via audio cables?
Are the effect and filter settings appropriate?
If you are using the filter, try changing the cutoff frequency. Some cutoff settings may filter out all of the sound.
Are the volume or expression settings too low?
Are the parameter settings such as Element Switch, Part Switch, Note Limit and Velocity Limit appropriate?
When the Element to which “Legato” of the XA Control parameter is assigned does not sound, is the Mono/Poly parameter of the
Element set to “Mono”? Or, is a value other than “Legato” of the XA Control parameter assigned to another Element within an
Element Group?
When the Element to which “Key Off Sound” of the XA Control parameter is assigned does not sound, are you releasing the note
after the AEG decays?
The “Key Off Sound” Element will take over the AEG level of the previous Element if both the Elements belong to the same
Element Group. To solve such a problem, release the note before the AEG level decays to minimum or set the “Key Off Sound”
Element to the different Element Group from the previous Elements.
[UTILITY] [F5] Control [SF2] MIDI Switch Local Control (page 269)
[UTILITY] [F2] I/O mLAN Monitor Setup (page 263)
[VOICE] [EDIT] [COMMON EDIT] [F6] Effect (page 107)
[PERFORM] [EDIT] [COMMON EDIT] [F5] Effect (page 149)
[SONG]/[PATTERN] [MIXING] [F5] Effect (page 234)
[VOICE] [EDIT] Element/Key selection [F3] Filter (page 117)
[PERFORM] [EDIT] Part selection [F4] EG Filter (page 158)
[SONG]/[PATTERN] [MIXING] [EDIT] Part selection [F4] EG Filter (page 235)
[PERFORM]/[SONG]/[PATTERN] [SEQ SETUP] [F2] MIDI Filter (page 270)
[UTILITY] [F1] General [SF1] Play Volume (page 259)
[VOICE] [EDIT] [COMMON EDIT] [F1] General [SF2] Play Mode Volume (page 98)
[VOICE] [EDIT] Element/Key selection [F4] Amplitude [SF1] Level/Pan Level (page 122)
[PERFORM] [EDIT] [COMMON EDIT] [F2] Level/MEF [SF1] Level Volume (page 145)
[PERFORM] [EDIT] Part selection [F1] Voice [SF1] Voice Volume (page 152)
[SONG]/[PATTERN] [MIXING] [F1] Part 1-16 Volume (page 232)
[VOICE] [EDIT] Element/Key selection [F1] Oscillator (page 112)
[PERFORM] [F2] Voice (page 138)
[PERFORM] [EDIT] Part selection [F1] Voice [SF1] Voice Part Switch (page 151)
[VOICE] [F2] Porta Mono/Poly Mode = mono (page 93)
[VOICE] [EDIT] Element selection [F1] Oscillator XA Control (page 112)
[VOICE] [EDIT] Element selection [F1] Oscillator Element Group (page 113)
[VOICE] [EDIT] Element selection [F1] Oscillator Element Group (page 113)
288


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha MOTIF XS7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha MOTIF XS7 in the language / languages: English as an attachment in your email.

The manual is 12,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha MOTIF XS7

Yamaha MOTIF XS7 Installation Guide - English - 6 pages

Yamaha MOTIF XS7 User Manual - English - 54 pages

Yamaha MOTIF XS7 Installation Guide - German - 10 pages

Yamaha MOTIF XS7 Installation Guide - German - 6 pages

Yamaha MOTIF XS7 User Manual - German - 320 pages

Yamaha MOTIF XS7 User Manual - Dutch - 320 pages

Yamaha MOTIF XS7 User Manual - French - 320 pages

Yamaha MOTIF XS7 User Manual - French - 54 pages

Yamaha MOTIF XS7 Installation Guide - French - pages

Yamaha MOTIF XS7 User Manual - Italian - 320 pages

Yamaha MOTIF XS7 User Manual - Portuguese - 320 pages

Yamaha MOTIF XS7 User Manual - Spanish - 320 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info