425049
15
Zoom out
Zoom in
Previous page
1/21
Next page
MG82CX/MG102C Owner’s Manual
15
Reference
Troubleshooting
* The MG82CX feature is described first, followed by the MG102C feature in brackets: MG82CX (MG102C).
Power doesn’t come on. Is the supplied power adaptor properly plugged into an appropriate AC wall outlet?
Is the supplied power adaptor properly plugged into the mixer?
No sound. Are microphones, external devices, and speakers connected correctly?
Are the channel GAIN controls, LEVEL controls, STEREO Master control set to
appropriate levels?
Is the MONITOR switch set properly?
Are your speaker cables connected properly, or are they shorted?
If the above checks do not identify the problem, call Yamaha for service. (Refer to
the page 59 for a list of service centers.)
Sound is faint,
distorted, or noisy.
Are the channel GAIN controls, LEVEL controls, STEREO Master control set to
appropriate levels?
Are two different instruments connected to the XLR-type and phone jacks, or to the
phone and RCA pin jacks on one channel? Please connect to only one of these
jacks on each channel.
Is the input signal from the connected device set to an appropriate level?
Are you applying the effects at an appropriate level?
Are microphones connected to the MIC input jacks on channels 1 to 5/6?
If you are using condenser microphones, is the PHANTOM +48 V switch turned ON?
No effect is applied.
(If you are using
MG82CX)
Check that the EFFECT control on each channel is correctly adjusted.
Be sure that the internal effect unit’s ON switch is turned ON.
Be sure that the EFFECT PARAMETER control and EFFECT RTN control are cor-
rectly adjusted.
I want spoken words to
be heard more clearly.
Be sure that the switches are ON.
Adjust the equalizers (HIGH, MID and LOW) on each channel.
I want to output a monitor
signal through speakers.
Connect a powered speaker to the EFFECT (AUX) jack*. Then adjust the output
signal by using the EFFECT (AUX) controls* on each channel.
Mounting to a Microphone Stand
1
Turn the mixer upside-down, and hold the
microphone-stand adaptor (BMS-10A; sold
separately) against the bottom of the mixer
so that the screw holes are aligned (
1).
Screw the adaptor firmly into place with the
two screws (
2).
2
Turn the mixer right-side up, and mount it
onto your microphone stand.
3
Loosen the angle adjustment wingnut (1),
adjust the mixer’s angle as desired (
2), and
then tighten the wingnut securely (
3).
For more information, refer to the BMS-10A Owner’s
Manual.
When using the mixer on a microphone stand, be
sure to set the stand on a level and stable sur-
face. Do not set up the stand in locations subject
to vibrations or wind.
Note that mixer may be damaged if the stand
should fall over. Attach the connection cables care-
fully so that the cables will not catch on the equip-
ment and cause it to fall. For example: arrange the
cables so that they run parallel with the micro-
phone pole down to the base of the stand.
Leave ample free space around the stand.
CAUTION
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha mg 102 c compact mengpaneel met 10 kanalen at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha mg 102 c compact mengpaneel met 10 kanalen in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha mg 102 c compact mengpaneel met 10 kanalen

Yamaha mg 102 c compact mengpaneel met 10 kanalen User Manual - German - 21 pages

Yamaha mg 102 c compact mengpaneel met 10 kanalen User Manual - French - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info