516888
18
Zoom out
Zoom in
Previous page
1/164
Next page
16 En
If there is a problem with the unit, check the following list first. If you cannot resolve the problem with the suggested solutions or if the
problem is not listed below, turn off and unplug the system, and consult the nearest authorized Yamaha dealer or service center.
TROUBLESHOOTING
General
Problem Cause Solution
Can’t turn on the unit.
The power cable is not connect firmly. Reconnect the power cable into the wall outlet and
the unit firmly.
The speakers make no sound.
The volume may be set to the minimum level. Adjust the volume level.
The source may be incorrect. Select the correct source.
Sound suddenly turns off.
The sleep ( P. 15) may be set. Turn on the system and play the source again.
Sound is cracked/distorted or there is
abnormal noise.
Input source volume is excessive, or volume of this
unit is excessive (especially Bass).
Adjust volume with VOLUME, or adjust Bass with
EQ ( P. 15).
The unit does not operate properly.
The unit may have received a strong electrical
shock such as lightning or excessive static
electricity, or power supply may have dropped.
Turn the system off, and disconnect the power
cable. Wait about 30 seconds, reconnect the power
cable, and turn the system on.
The system turns on but immediately
shuts off.
A digital or high-frequency equipment
produces noises.
The unit may be placed too close to the digital or
high-frequency equipment.
Place the unit further away from the equipment.
The clock setting has been cleared.
The unit is left more than one week after you
disconnect the power cable from the wall outlet.
Plug the power cable into the wall outlet firmly, and
set the clock again ( P. 5).
iPod does not play back at the alarm time
even if SOURCE is set to iPod.
The iPod is not connect in the iPod dock firmly. Remove an iPod from the unit, and then connect it
in the iPod dock again ( P. 2).
ALARM TYPE switch is set to BEEP. Set ALARM TYPE to SOURCE + BEEP or
SOURCE ( P. 13).
Clock flashes and the unit cannot be
operated.
CLOCK switch on the rear panel is set to SET, and
this unit is in clock setting mode.
Set CLOCK switch to CLOCK1 or CLOCK2
( P. 5).
iPod
Problem Cause Solution
No sound.
The iPod is not connect in the iPod dock firmly. Remove an iPod from the unit, and then connect it
in the iPod dock again ( P. 2).
The iPod software version has not been updated. Download the latest iTunes version from the Apple
website, and update the iPod software to the latest
version.
The iPod does not charge up.
The iPod is not connect in the iPod dock firmly. Remove an iPod from the unit, and then connect it
in the iPod dock again ( P. 2).
The system is set to power save mode ( P. 2).
Press to cancel the power save mode.
The iPod indicator flashes twice, and
repeated 3 times, after connecting the
iPod.
The iPod being used is not supported by the unit. Use a supported iPod ( P. 1 9).
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha ISX-800 Restio at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha ISX-800 Restio in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 5,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info