E-33
English
Winding the tape
1 If during playback, first press the stop button.
2 Next press the fast wind or fast wind button to
wind the tape.
3 Press the stop button to stop.
Note
When the tape is wound to the end, this unit will then function
as described below, according to the setting of the reverse
MODE selector button.
: The tape stops at the end.
: When the tape reaches the end, playback
automatically starts from the reverse side.
Searching for the beginning of a
desired selection
Carry out the following operation during playback to find the
beginning of a desired selection on the tape.
To listen to the same selection
Press the button if the direction of the current playback
is .
Press the button if the direction of the current playback
is .
To listen to the next selection
Press the button if the direction of the current playback
is .
Press the button if the direction of the current playback
is .
Notes
•
This function may not work for tapes with
* Material with long pauses or quiet passages.
* Low recording levels or excessive noise.
* Pauses of less than 4 seconds between selections.
•
If searching is carried out at the first or the last part of a
selection, the desired selection may not be found.
Direct operation
When the power is off (in the standby mode), pressing the
TAPE 1/2 input selector button or the play button will turn the
power on and start playback of the selected tape
automatically.
When the power is on, even if an input source other than tape
deck is selected, pressing the play button (or the fast wind
button) will start playback (or fast winding) directly.
Notes
•
When removing the tape, press the stop button, and
then open the cassette compartment.
•
Even if you press the TAPE 1/2 input selector button on
the front panel or the TAPE 1/2 button on the remote
control transmitter during playback, the playback of
currently selected tape cannot be changed to the other
one though the tape number indicator on the display
changes.
TAPE DECK OPERATION
