554951
44
Zoom out
Zoom in
Previous page
1/46
Next page
E-36
Appendix
CD player
Problem
A disc cannot be played back normally, or
there is a noise during play.
Play will not begin even if disc is loaded.
No sound.
Sound stops suddenly (always at the
same spot).
Tape will not move during playback or
recording.
Recording is not possible.
Sound is distorted or fades out, or stereo
balance is poor.
Poor sound quality.
Excessive noise.
Tape travel stops in middle of playback or
recording.
The beginning of desired selections on
tape cannot be found.
Remote control does not work.
TV functions strangely when the remote
control is used.
Cause
The disc is not a standard type.
Disc is upside down.
Disc is dirty.
The input source selection is incorrect.
Disc is dirty.
Volume is set too high.
Slack tape wrapped around pinch roller.
Erasure prevention tab is broken off.
Head is dirty.
Head is dirty.
Tape is worn.
Tape encoded with Dolby NR is played
back with this system’s Dolby NR off.
Tape not encoded with Dolby NR is played
back with this system’s Dolby NR on.
Head has become magnetized.
Slack tape coming out of cassette shell.
Tape is creased or torn.
Endless tape is being used.
Silent gaps between selections are too
short.
Excessively soft passages in middle of
selections.
Conversation, etc. is recorded.
Batteries are dead.
Remote control is too far away or tilted too
much.
Direct sunlight or lighting (of an inverter
type of fluorescent lamp, etc.) is striking
the remote control sensor of the main unit.
Remote control is being used near TV set
with a remote control sensor.
What to Do
Play another disc.
Load disc label side facing up.
Clean disc.
Select the CD player by pressing INPUT
or button until “CD” is illuminated on the
display.
Clean disc.
Lower volume.
Take up slack with a pencil before using.
Replace tape or cover erasure prevention hole
with cellophane tape.
Clean heads.
Clean heads.
Replace tape.
Press the DOLBY NR button to turn it on.
Press the DOLBY NR button to turn it off.
Demagnetize heads with head eraser.
Take up slack by turning reels with a pencil.
Replace with new tape.
Do not use endless tapes.
The function of searching for the beginning of
desired selections will not operate unless the
silent gaps between selections are at least four
seconds long.
Replace batteries.
Use within 6 m and 60° radius.
Change position of the main unit.
Relocate the main unit away from the TV or cover
TV’s remote control sensor.
Remote control
Tape deck
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha GX-500RDS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha GX-500RDS in the language / languages: English as an attachment in your email.

The manual is 1,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info