40
Timer recording
(To record a tuner program)
1 Load a blank tape into the DECK B cassette
compartment.
2 If desired, change the setting of the reverse mode and
the Dolby NR position.
3 Tune to the station of which program you want to record.
4 Follow step 2 of the “Timer play” on page 38 and 39.
* In step
➁, press the TUNER input selector button, and
then press the TIMER REC button. (“REC” will flash on
the display and the indicator over the TIMER REC
button will light up.)
* In step
➂, set the time when you want to begin the
timer recording.
* In step
➃, set the time when you want to finish the
timer recording.
5 Press the TIMER button.
(The power will be turned off automatically.)
* If the normal listening mode (the state which had been
selected before you began setting the timer recording)
is restored before you press the TIMER button, select
and follow either of the two methods below.
•
Press the DISPLAY button, and then press the
TIMER button. (The power is still on.)
•
Press the POWER switch to turn the power off, and
then press the TIMER button. (The power is turned
off.)
To confirm the timer time setting
Press the DISPLAY button.
To cancel the setting of timer recording
Press the DISPLAY button once or more so that “REC”
flashes on the display. While “REC” is flashing, press the
TIMER REC button.
(The indicator over the button will go out.)
* Unless the AC supply lead is unplugged or there is a
power failure for more than 5 minutes, the time set on the
timer will be retained until it is reset.
Note
When the timer recording is finished, the timer setting is
automatically canceled to avoid repeating timer recording of
the same setting.
HOW TO USE THE BUILT-IN TIMER
TUNER
5
TIMER REC
DISPLAY
