E-32
HOW TO USE THE BUILT-IN TIMER
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns off automatically.
1 Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For tape deck:
Load a tape into the cassette compartment, and select
the tape by pressing the DECK A/B button so that the
corresponding indicator lights up.
For CD player:
Load a disc on the disc table.
2 Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
At each mode, make a setting for the timer play, referring
to the setting procedure described below.
➀ Frequency display
(Only when the tuner is selected)
➁ Current time
Check to be sure that the current time is correct.
➂ Source selecting mode
(CD, TAPE, TUNER SELECT)
Select the source (TAPE, TUNER or CD) to be
played by pressing the corresponding input
selector button.
➃ Time setting mode (ON TIME)
Set to the time when you want to begin the timer
play by pressing the HOUR button and the MIN
button with the TIME ADJ button kept being
pressed.
➄ Time setting mode (OFF TIME)
Set to the time when you want to finish the timer
play (to turn this unit off) by pressing the HOUR
button and the MIN button with the TIME ADJ
button kept being pressed. Even if you do not set
the time, it has already been set so that the timer
play finishes after 1 hour.
* The display mode will be changed to the display of a
normal source listening mode after about 8 seconds
elapse automatically. If the mode is changed before the
setting is completed, call the mode again by pressing
the DISPLAY button once or more.
3 Press the TIMER button so that “TIMER” appears on the
display.
4 If you will not use this unit until the timer play begins, turn
the power off by pressing the POWER switch.
→
→→
→→
DISPLAY
DISPLAY
Input selector buttons
Input selector buttons
HOURPOWER
POWER
DECK A/B
DECK A/B
MIN
TIMER
TIME ADJ
