E-21
English
• When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
• The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
• Adjusting the VOLUME control and using the built-in
graphic equalizer and sound field processor have no
effect on the recorded sound.
• For the tape deck, the deck which can be used for
recording is the DECK B only. When recording, be sure to
load a tape into the DECK B cassette compartment.
CD synchronized recording
1 Press the CD input selector button and load the disc to be
recorded.
2 Load a tape into the DECK B cassette compartment.
* Wind past the beginning part of the tape on which
recording cannot be performed.
3 When recording with the Dolby NR system, press the
Dolby B NR button so that the indicator over the button
lights up. If not, set it off.
* For details on the Dolby noise reduction, refer to the
“Dolby NR (Noise Reduction) system” on page 20.
4 If desired, switch the reverse mode by pressing the
reverse MODE selector button.
When the tape is set so that side A faces you, recording
will be done as follows automatically according to the
selected reverse mode.
..........Side A only
..........Side A
→
Side B
5 Press the REC/PAUSE button.
* The indicator over the button will flash.
6 Start CD playback by pressing the play/pause button.
To stop recording
Press the stop button of the tape deck.
(At this time, CD playback does not stop.)
Note
Even if the stop button of the CD player is pressed,
recording will not stop.
Recording programmed tracks
Programmed tracks can also be recorded in the same way.
11 Program desired tracks. (Refer to page 12 for the
programming procedure.)
22 Follow steps 2–6 described above.
RECORDING A COMPACT DISC
6
1
1
4
3
52
