HOW TO USE THE BUILT-IN TIMER
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns into the standby mode automatically.
1 Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For CD player:
Load a disc on the disc table. If more than one disc are
loaded on the disc table, select the disc by using the
DISC selector buttons or the DISC SKIP button.
2 Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
On each mode, make a setting for the timer play,
following the setting procedure described below.
➀ Current time (TIMER on/off mode)
➁ Source selecting mode (TUNER, CD)
➂ ON TIME/Time setting mode
➃ OFF TIME/Time setting mode
➄ Normal display mode
Note
The display mode will be changed to the next mode
after about 8 seconds elapse in turn automatically. If the
mode is changed before the setting is completed, call the
mode again by pressing the DISPLAY button once or
more.
Setting procedure:
➀ Current time
Check to be sure that the current time is correct, and
press the TIMER button so that “TIMER” lights up on
the display.
➁ Source selecting mode
Select the source (TUNER or CD) to be played with
the INPUT SELECTOR.
* If “TUNER” is selected, soon it is changed to the
frequency display mode. In this mode, you can
select the station to listen to by the timer play by
using the PRESET/TUNING/BAND selector button,
A/B/C/D/E button and / buttons.
→
→→→→
