30889
33
Zoom out
Zoom in
Previous page
1/38
Next page
31
INTRODUCTIOIN PREPARATIONS PLAYBACK SETUP MENU
APPENDIX
English
APPENDIX
TROUBLESHOOTING
If this unit fails to operate normally, check the following points to determine whether the fault can be corrected, or if the fault
is not listed in the PROBLEM column, disconnect the power code and contact your authorized YAMAHA dealer or service
center.
General
PROBLEM POSSIBLE CAUSE WHAT TO DO
Refer to
Page
This unit fails to turn
on when the POWER
switch is pressed.
The power cord is not connected or the plug
is not completely inserted.
Firmly connect the power cord.
The voltage selector on the rear panel is not
set to the proper position.
Disconnect the power cord and set the
selector to the position for your local main
voltage.
This unit does not work
normally.
This unit is affected by an external shock
(lightning, excessive static electricity,
incorrect operation, etc.)
Turn the power off and disconnect the power
cord. After about 30 seconds have passed,
connect the power and operate the unit again.
Playback does not
start.
The disc is damaged. Check the disc carefully; replace it if
necessary.
There is moisture on the laser pickup. Wait 20 to 30 minutes after switching the unit
ON before trying to play a disc.
The disc has been loaded upside down. Reload the disc with the label side facing up. 13
The disc is dirty. Clean the disc. 3
Play is delayed, or
starts at the wrong
place.
The disc may be scratched or damaged. Check the disc carefully; replace it if
necessary.
No sound. Incorrect output cable connections. Connect the cables properly. If the problem
persists, the cables may be defective.
9
Incorrect amplifier operation. Set the amplifier controls to the correct input
selection.
Sound distorted. V.S.S effect is emphasized too much. Turn V.S.S. off. 24
This unit is being subjected to vibrations or
impacts.
Relocate the unit.
The disc is dirty. Clean the disc. 3
Sound ‘hums’. Incorrect cable connections. Securely connect the audio cables. If the
problem persists, the cables may be defective.
9
Noise from a nearby
tuner.
The tuner is too close to the unit. Place the tuner and the unit farther apart.
Noise from inside of
the unit.
The disc maybe warped. Replace the disc.
The batteries are weak. Replace all batteries with new ones. 7
Sound ‘skips’.
The remote control
does not work.
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
Relocate the unit. 7
No picture. Incorrect video connections. Connect this unit and other equipment
properly.
10
This unit’s video input is not selected at the
video monitor.
Set the video input at the video monitor to the
position where this unit is connected (e.g.
VCR2).
This unit does not
recognize discs (‘No
disc’ appears on the
display, or the display
shows the status when
no disc is loaded).
The disc(s) is not placed properly. Place the disc(s) correctly along the guide(s).
107-C996(E)31-35 7/31/0, 4:17 PM31
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha DVDC996 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha DVDC996 in the language / languages: English as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info