599136
141
Zoom out
Zoom in
Previous page
1/163
Next page
138
VAttach the speaker box.
Remove the speaker box cover (attached with
“Velcro”) from the speaker box. Gently rest the speaker
box onto the corresponding brackets on the front legs.
(Be careful not to touch the speakers when handling
the speaker box. Damage may result.)
Make sure the
speaker cord is extending out from the rear of the
speaker box. Secure the speaker box to the main key-
board unit using four screws on each side. Insert the
speaker cord connector into the corresponding socket
on the main keyboard unit, making sure that the pro-
truding clip on the connector is facing left.
BAttach the pedal box assembly.
Before attaching the rear leg and pedal box assembly,
insert the pedal cord plug extending from the rear leg
into the corresponding socket in the main unit. Make
sure that the protruding clip on the connector is facing
up. Put the excess cord into the leg and securely attach
the rear leg and pedal assembly using 5 screws for each
leg (three screws per leg and two screws on each leg
bracket).
NSecure the speaker box.
Stand the main unit on its legs and securely attach the
speaker box to the bracket on the front legs using two
screws for each bracket. If it is impossible to align the
bracket holes with the speaker box holes, slightly
loosen the three screws on each of the front legs, align
the holes, and secure the speaker box. After the speaker
box is firmly attached, retighten the screws on the front
legs firmly. Put the speaker box cover back in place
with the “Velcro” on the cover and speaker box. (Make
sure the cut out corners of the speaker cover mask the
brackets.)
4
VDen Lautsprecherkasten montieren.
Nehmen Sie die von Klettband gehaltene Bespannung
vom Lautsprecherkasten ab. Setzen Sie den
Lautsprecherkasten vorsichtig auf die Halterungen an
den vorderen Beinen. (Vermeiden Sie dabei unbedingt
ein Berühren der Lautsprechermembrane.)
Das
Lautsprecherkabel muß an der Hinterseite (d.h. oben)
aus dem Lautsprecherkasten ragen. Schrauben Sie den
Lautsprecherkasten mit jeweils vier Schrauben an
Vorder- und Hinterseite an der Haupteinheit fest.
Schließen Sie dann das Lautsprecherkabel an die
Buchse der Haupteinheit an (die Führungsnase am
Stecker muß dabei nach links weisen).
BDie Pedalkastengruppe montieren.
Bevor Sie die Pedalkastengruppe mit den hinteren Bei-
nen montieren, schließen Sie das aus dem einen Bein
ragende Pedalkabel an die entsprechende Buchse der
Haupteinheit an (die Führungsnase am Stecker muß
dabei nach oben weisen). Schieben Sie überlanges
Kabel wieder in das Bein zurück, und schrauben Sie
dann die Pedalkastengruppe mit fünf Schrauben pro
Bein (jeweils 3 für das Bein selbst und 2 für die
Halterung am Bein) an die Haupteinheit.
NDen Lautsprecherkasten an den vorderen
Beinen sichern.
Stellen Sie das Instrument nun auf seine Beine, um den
Lautsprecherkasten zusätzlich mit jeweils zwei Schrau-
ben an die Halterungen der beiden vorderen Beine zu
schrauben. Sollten die Schraubenbohrungen nicht zur
Deckung gebracht werden können, lösen Sie die
Befestigungsschrauben der vorderen Beine ein wenig.
Nach Festschrauben des Lautsprecherkastens dürfen Sie
jedoch nicht vergessen, die Schrauben der Beine wieder
fest anzuziehen. Bringen Sie nun die Bespannung wieder
an, indem Sie die Klettband-Gegenstücke an
Bespannungsrahmen und Lautsprecherkasten aufeinander
ausrichten. (Die Halterungen müssen in den ausgesparten
Mulden des Bespannungsrahmens zu liegen kommen.)
Four screws on each side
Jeweils vier Schrauben an Vorder-
und Hinterseite
Quatre vis de chaque côté
Cuatro tornillos en cada lado
141


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CVP-69 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CVP-69 in the language / languages: English as an attachment in your email.

The manual is 2,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CVP-69

Yamaha CVP-69 User Manual - German - 163 pages

Yamaha CVP-69 User Manual - French - 163 pages

Yamaha CVP-69 User Manual - Portuguese - 40 pages

Yamaha CVP-69 User Manual - Spanish - 163 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info