593738
209
Zoom out
Zoom in
Previous page
1/224
Next page
CVP-309/307 Owner’s Manual
209
Appendix
CVP-309/307: Keyboard Stand Assembly
CAUTION
Be careful not to confuse parts, and be sure to install all
parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
Assembly should be carried out by at least two persons.
Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
Be sure to tighten up
all screws upon com-
pleting assembly of
each unit.
•To disassemble,
reverse the assembly
sequence given below.
1
Remove all parts from the box. Confirm that all
parts shown in the illustration are provided.
2
With the key cover closed and the keyboard side
on the bottom, lean the unit against the wall.
CAUTION
Be careful not to pinch your fingers.
The top part of the music rest is not fixed. When you lean
the unit against the wall, support the music rest with your
hand so that the music rest will not fall.
CAUTION
Do not place the main unit
with the rear side facing
down.
Do not lay the main unit
upside-down on the floor.
1
Spread a large soft cloth such as a blanket on the
floor in front of the wall.
2
Place the main unit on the soft cloth with its
keyboard side facing the wall.
3
Place a protective pad on the soft cloth, so that,
when you place the main unit on the floor with its
keyboard side touching the floor, the pad comes
under the keyboard side, and is located about 10cm
(a little more than four inches) to the high key side
from the floppy disk drive. The pad will protect the
floppy disk drive so that it will not be damaged by
touching the floor.
4
Raise the rear of the main unit until it leans
against the wall. When raising the unit, place the
keyboard side at the bottom and make it sit on the
protective pad.
Be careful not to allow the unit to fall or slip.
Also, insert the soft cloth between the main unit
and the wall to protect the unit from being
damaged by hitting the wall or any other object.
CAUTION
Be sure to use a protective pad to avoid a damage to the
floppy disk drive. If the drive touches the floor when you
raise the unit to lean it against the wall, too much pressure
may be applied to the drive, possibly causing serious dam-
ages to the drive.
(CVP-307)
Spread a large soft cloth, such as a blanket, on the floor.
Place the unit on the cloth with the keyboard side on
the bottom and lean the unit against the wall so that the
unit will not fall or slip. Place a soft cloth against the
wall to protect the instrument and wall from scratches.
3
Attach the front legs.
Have a Phillips-head (+) screw-
driver ready.
Rear legFront leg (left)
AC power cord
Front leg (right)
Pedal box
5x18 mm fixing
screws × 14
Bundled pedal
cord inside
CAUTION
To prevent the
key cover from
accidentally
opening during
assembly, press
down on the
key cover, mak-
ing sure that
the sheet
(shown) remain
in place.
Protective pad
(CVP-309)
Be sure to position the keyboard side on the bottom.
CAUTION
Please do not touch the speaker
net. Doing so may damage the
speaker inside.
Incorrect
Incorrect
Protective pad
Floppy disk drive
Large soft cloth
Floppy disk drive
Protective pad
(CVP-309)
Front leg (right) Front leg (left)
1 Fix the front right
leg to the bottom
surface of the unit
using two screws.
2 Fix the front right leg
to the speaker box
using two screws.
3 Fix the front left leg in the same way.
If the screw holes do not align, loosen the other screws and
adjust the position of the front leg.
4(CVP-309) Slowly tilt the main unit forward
until front legs reach the floor.
CVP-309_E.book Page 209 Monday, October 23, 2006 9:07 AM
209


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CVP-309 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CVP-309 in the language / languages: English as an attachment in your email.

The manual is 12,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CVP-309

Yamaha CVP-309 User Manual - German - 224 pages

Yamaha CVP-309 User Manual - Dutch - 224 pages

Yamaha CVP-309 User Manual - Danish - 223 pages

Yamaha CVP-309 User Manual - French - 224 pages

Yamaha CVP-309 User Manual - Italian - 231 pages

Yamaha CVP-309 User Manual - Portuguese - 224 pages

Yamaha CVP-309 User Manual - Swedish - 221 pages

Yamaha CVP-309 User Manual - Spanish - 224 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info