593642
42
Zoom out
Zoom in
Previous page
1/68
Next page
CVP-109/107/105/103/700
42
CAttach the rear panel (B).
With the rear panel slightly angled as shown in the illus-
tration, lower it onto the feet’s protruding edge at the rear
of the pedal box. Then, while eliminating any gaps be-
tween the rear and side panels, secure the top of the rear
panel to the side panel brackets using two 4 x 12 mm
round-head screws 2 . Finally, secure the bottom of the
rear panel to the pedal box using four 4 x 20 mm tapping
screws 3.
VInstall the main unit (A).
Place the main unit (A) on the side panels (D) with the
screws on its bottom panel (toward the rear of the main
unit) just behind the grooves in the brackets located at the
top of the side panels. Then slide the main unit forward
until it stops. WATCH YOUR FINGERS WHEN DO-
ING THIS!!
Align the holes on the bottom panel of the main unit with
the holes in the brackets on the side panels (also center
the main unit to produce equal clearance on the left and
right sides, as shown in the illustration), then screw in and
securely tighten the four 6 x 16 millimeter flat-head
screws 4.
CAUTION
Do not hold the keyboard in any position other than the position
shown in the above illustration.
Fingers can become pinched between the main unit and the rear or
side panels, be extra careful so as not to drop the main unit.
BConnect the pedal cord.
The pedal cord from the pedal box must be plugged into
the PEDAL connector on the rear of the main unit. Once
connected, attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
• 4 x 20 mm tapping screws 3
• 4 x 20 mm Schneidschrauben 2
• Vis auto-taraudeuses 4 x 20 mm 2
• Tornillos de autoenrosque de 4 x 20 mm 2
43
CMontieren Sie die Rückwand (B).
Setzen Sie die Rückwand leicht abgewinkelt, wie in der
Abbildung gezeigt, hinter dem Pedalkasten auf die her-
vorspringenden Teile der Füße auf. Schrauben Sie dann
die Rückwand oben mit zwei 4 x 12 mm Halbrund-
schrauben 2 so an den Seitenwänden fest, daß kein Spiel
zwischen Rückwand und Seitenwänden verbleibt. Schrau-
ben Sie die Rückwand abschließend noch mit vier 4 x 20
mm Schneidschrauben 3 an den Pedalkasten.
VMontieren Sie die Tastatureinheit (A).
Setzen Sie die Tastatureinheit (A) so auf den fertigen
Ständer, daß die beiden Schrauben an ihrer Unterseite
hinter den Winkelblechen mit Führungsschlitz an der
Hinterseite des Ständers zu liegen kommen. Schieben Sie
die Tastatureinheit dann bis zum Anschlag in die Schlitze.
KLEMMEN SIE IHRE FINGER DABEI NICHT
EIN!!
Richten Sie die Schraubenbohrungen an der Unterseite
der Tastatureinheit mit den Bohrungen der Winkelbleche
aus (achten Sie auch darauf, daß sie mittig auf dem Stän-
der steht, wie in der Abbildung gezeigt). Schrauben Sie
die Tastatureinheit dann mit den vier 6 x 16 mm Senk-
schrauben 4 am Ständer fest.
VORSICHT
Halten Sie die Tastatureinheit nur wie in der obigen Abbildung!
Achten Sie darauf, daß Sie Ihre Finger nicht zwischen Tastatur-
einheit und den Seitenwänden bzw. der Rückwand einklemmen —
die Tastatureinheit könnte dadurch zu Fall kommen!
BSchließen Sie das Pedalkabel an.
Das vom Pedalkasten kommende Kabel muß in die
PEDAL-Buchse an der Rückwand der Haupteinheit
gesteckt werden. Befestigen Sie dann die Kabelhalter an
der Rückwand wie in der Abbildung gezeigt, und
klemmen Sie das Kabel in diese Halter.
• 4 x 12 mm round-head screws 2
• 4 x 12 mm Halbrundschrauben 2
• Vis à tête ronde de 4 x 12 mm 2
• Tornillos de cabeza redonda de 4 x 12 mm 2
B
• Be sure to place your hands
at least 15 centimeters from
either end of the main unit when
positioning it.
• Mindestens 15 cm innen unter die
Tastatureinheit greifen.
• Placez bien vos mains à 15 cm au moins des extrémités du
clavier, lors de sa mise en place.
• Asegúrese de colocar las manos por lo menos a 15 centímetros
desde los extremos de la unidad principal cuando la sitúe.
15 cm
15 cm
D
D
A
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CVP-105 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CVP-105 in the language / languages: French as an attachment in your email.

The manual is 3,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CVP-105

Yamaha CVP-105 User Manual - English - 68 pages

Yamaha CVP-105 User Manual - English - 235 pages

Yamaha CVP-105 User Manual - German - 68 pages

Yamaha CVP-105 User Manual - German - 235 pages

Yamaha CVP-105 User Manual - Dutch - 292 pages

Yamaha CVP-105 User Manual - French - 235 pages

Yamaha CVP-105 User Manual - Italian - 246 pages

Yamaha CVP-105 User Manual - Portuguese - 150 pages

Yamaha CVP-105 User Manual - Swedish - 247 pages

Yamaha CVP-105 User Manual - Spanish - 68 pages

Yamaha CVP-105 User Manual - Spanish - 235 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info