593347
62
Zoom out
Zoom in
Previous page
1/68
Next page
CVP-109/107/105/103/700
62
VAttach the front legs.
Securely attach the two front legs using three 5 x 12
millimeter large screws for each leg (use a Philips “+”
screwdriver) as shown in the illustration. Make sure that
the screws are firmly tightened.
BAttach the speaker box.
Remove the speaker box cover (attached to the speaker
box in 6 places with plastic plugs) from the speaker box.
Gently rest the speaker box onto the corresponding brack-
ets on the front legs. (Be careful not to touch the speakers
when handling the speaker box. Damage may result.)
Make sure the speaker cord is extending out from the rear
of the speaker box. Loosely secure the speaker box to the
main keyboard unit using four 5 x 12 millimeter large
screws on both the front and back. (The speaker will be
secured in step N.) Insert the speaker cord connector into
the corresponding socket on the main keyboard unit, mak-
ing sure that the protruding clip on the connector is facing
up.
NAttach the pedal box assembly.
CAUTION
When you lift the pedal box assembly, make sure that you lift by
both legs.
Before attaching the rear leg and pedal box assembly,
insert the pedal cord plug extending from the left leg into
the corresponding socket in the main unit. Make sure that
the protruding clip on the connector is on the right. Put
the excess cord into the leg and loosely secure the rear leg
and pedal assembly using six 5 x 12 millimeter large
screws for each leg (four screws per leg and two screws
on each leg bracket). Once the rear leg and pedal assem-
bly has been loosely attached, go back and tighten all 12
of the screws on the rear leg and pedal assembly, and also
secure the 8 screws on the speaker box.
• Four screws on each side
• Jeweils vier Schrauben an Vorder- und
Hinterseite
• Quatre vis de chaque côté
• Cuatro tornillos en cada lado
VDie vorderen Beine montieren.
Schrauben Sie die beiden vorderen Beine mit jeweils drei
Schrauben (5 x 12 mm, Kreuzschlitzschraubendreher
verwenden!) gut am Clavinova fest, wie in der Abbildung
gezeigt. Ziehen Sie die Schrauben fest an.
BDen Lautsprecherkasten montieren.
Nehmen Sie die Bespannung (wird an 6 Punkten von
Plastikdübeln gehalten) vom Lautsprecherkasten ab.
Setzen Sie den Lautsprecherkasten vorsichtig auf die
Halterungen an den vorderen Beinen. (Vermeiden Sie
dabei unbedingt ein Berühren der
Lautsprechermembrane.) Das Lautsprecherkabel muß an
der Hinterseite (d.h. oben) aus dem Lautsprecherkasten
ragen. Befestigen Sie die Lautsprecherbox provisorisch
mit jeweils vier Schrauben (5 x 12 mm) vorn und hinten
an der Haupttastatur, ohne die Schrauben anzuziehen.
(Die endgültige Befestigung des Lautsprechers erfolgt in
Schritt N). Schließen Sie dann das Lautsprecherkabel an
die Buchse der Haupteinheit an (die Führungsnase am
Stecker muß dabei nach oben weisen).
NDie Pedalkastengruppe montieren.
VORSICHT
Halten Sie die Pedalkasten-Baugruppe beim Heben stets an beiden Beinen.
Bevor Sie die Pedalkastengruppe mit den hinteren Beinen
montieren, schließen Sie das aus dem linken Bein ragende
Pedalkabel an die entsprechende Buchse der Haupteinheit
an (die Führungsnase am Stecker muß dabei nach rechts
weisen). Schieben Sie das überlange Kabel wieder in das
Bein zurück, und schrauben Sie dann die hinteren Beine
mit der Pedalkastengruppe provisorisch mit sechs
Schrauben (5 x 12 mm) pro Bein (jeweils 4 für das Bein
selbst und 2 für die Halterung am Bein) an die
Haupteinheit. Nun können Sie alle 12 Schrauben an der
Hinterbein-/Pedalbaugruppe und die 8 Schrauben zur
Befestigung der Lautsprecherbox fest anziehen.
CVP-109
54
• Three screws on each side
• Drei Schrauben pro Bein
• Trois vis de chaque côté
• Tres tornillos en cada lado
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CVP-103M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CVP-103M in the language / languages: Spanish as an attachment in your email.

The manual is 3,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CVP-103M

Yamaha CVP-103M User Manual - English - 68 pages

Yamaha CVP-103M User Manual - German - 68 pages

Yamaha CVP-103M User Manual - French - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info