557316
27
Zoom out
Zoom in
Previous page
1/48
Next page
Setup Procedures
18
! Connect the IDE cable.
Connect the 40-pin IDE cable to the secondary IDE connector on
the motherboard and to the IDE interface connector on the rear
panel of the CRW2100E drive. Be sure to plug in the cable so
that the colored line on the cable corresponds to pin #1 on the
right end of the connector.
1
Motherboard
IDE cable
IDE cable
Magnified IDE
connector
section
Colored line
Primary
(connector)
Secondary
(connector)
CSEL
SLAVE
MASTER
IDE
INTERFACE
CONNECTOR
DC INPUT
1
+
5V
G
+
12
V
AUDIO OUT
DIGITAL ANALOG
DG
RGL
If an IDE cable has already been connected to the secondary
IDE connector, replace it with the IDE cable.
If you wish to continue using the IDE device you just
removed, connect it to an available primary or secondary IDE
connector.
When you connect two IDE devices to one IDE cable, be sure
to assign them master or slave uniquely.
n To make the best use of the performance of the CRW2100E drive,
Yamaha recommends you connect it as a sole secondary master.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CRW-2100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CRW-2100 in the language / languages: English as an attachment in your email.

The manual is 3,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info