593326
56
Zoom out
Zoom in
Previous page
1/66
Next page
56
CLP-950/930
2
X
Montieren Sie die Rückwand (B).
Setzen Sie die Rückwand leicht abgewinkelt, wie in der Abbil-
dung gezeigt, hinter dem Pedalkasten auf die hervorspringenden
Teile der Füße auf. Schrauben Sie dann die Rückwand oben mit
zwei 4 x 12 mm Halbrundschrauben 2 so an den Seitenwänden
fest, daß kein Spiel zwischen Rückwand und Seitenwänden ver-
bleibt. Schrauben Sie die Rückwand abschließend noch mit vier 4
x 20 mm Schneidschrauben 3 an den Pedalkasten.
C
Montieren Sie die Tastatureinheit (A).
Setzen Sie die Tastatureinheit (A) so auf den fertigen Ständer,
daß die beiden Schrauben an ihrer Unterseite hinter den Winkel-
blechen mit Führungsschlitz an der Hinterseite des Ständers zu
liegen kommen. Schieben Sie die Tastatureinheit dann bis zum
Anschlag in die Schlitze. KLEMMEN SIE IHRE FINGER
DABEI NICHT EIN!!
Richten Sie die Schraubenbohrungen an der Unterseite der
Tastatureinheit mit den Bohrungen der Winkelbleche aus
(achten
Sie auch darauf, daß sie mittig auf dem Ständer steht, wie in der
Abbildung gezeigt), um die Tastatureinheit dann mit den vier 6 x
16 mm Senkschrauben 4 festzuschrauben. Die vier Schrauben
können von der Vorderseite her eingedreht werden.
VORSICHT
Halten Sie die Tastatureinheit nur wie in der obigen Abbildung!
Achten Sie darauf, daß Sie Ihre Finger nicht zwischen Tastatur-
einheit und den Seitenwänden bzw. der Rückwand einklemmen —
die Tastatureinheit könnte dadurch zu Fall kommen!
X
Attach the rear panel (B).
With the rear panel slightly angled as shown in the illustration,
lower it onto the feet’s protruding edge at the rear of the pedal
box. Then, while eliminating any gaps between the rear and side
panels, secure the top of the rear panel to the side panel brackets
using two 4 x 12 mm round-head screws 2. Finally, secure the
bottom of the rear panel to the pedal box using four 4 x 20 mm
tapping screws 3.
C
Install the main unit (A).
Place the main unit (A) on the side panels (D) with the screws
on its bottom panel (toward the rear of the main unit) just behind
the grooves in the brackets located at the top of the side panels.
Then slide the main unit forward until it stops. WATCH YOUR
FINGERS WHEN DOING THIS!!
Align the holes on the bottom panel of the main unit with the
holes in the brackets on the side panels
(also center the main unit
to produce equal clearance on the left and right sides, as shown in
the illustration), then use the four 6 x 16 millimeter flat-head
screws 4 to attach the main unit. The four screws can be at-
tached from the front.
CAUTION
Do not hold the keyboard in any position other than the position
shown in the above illustration.
Fingers can become pinched between the main unit and the rear or
side panels, be extra careful so as not to drop the main unit.
B
B
D
4 x 20 mm tapping screws 3
4 x 20 mm Schneidschrauben 3
Vis auto-taraudeuses 4 x 20 mm 3
Tornillos de autoenrosque de 4 x 20 mm 3
4 x 12 mm round-head screws 2
4 x 12 mm Halbrundschrauben 2
Vis à tête ronde de 4 x 12 mm 2
Tornillos de cabeza redonda de 4 x 12 mm 2
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-950C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-950C in the language / languages: German as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-950C

Yamaha CLP-950C User Manual - English - 66 pages

Yamaha CLP-950C User Manual - Dutch - 64 pages

Yamaha CLP-950C User Manual - Danish - 62 pages

Yamaha CLP-950C User Manual - French - 66 pages

Yamaha CLP-950C User Manual - Italian - 57 pages

Yamaha CLP-950C User Manual - Portuguese - 32 pages

Yamaha CLP-950C User Manual - Swedish - 60 pages

Yamaha CLP-950C User Manual - Spanish - 66 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info